MERCEDES SLR MCLAREN C199 300 5.4L V8 32V KOMPRESSOR 478kW/641HP ME2.8.1

ECU BOSCH ME2.8 · 650 CV (478 kW) · 5400 cc · Benzina sovralimentato

ECU-databaseMERCEDES › MERCEDES SLR MCLAREN C199 300 5.4L V8 32V KOMPRESSOR 478kW/641HP ME2.8.1

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 2 firmwareversies

Voertuiggegevens

MerkMERCEDES
ModelSLR MCLAREN C199
Motor300 5.4L V8 32V KOMPRESSOR 478kW/641HP ME2.8.1
Standaard vermogen650 CV / 478 kW
Cilinderinhoud5400 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelME2.8
Geheugen / EPROM29F400 PSOP44 4Mbit - Flash 256K x 16

Beschikbare tuning-opties:

  • Base timing
  • Lambda/AFR full load/WOT
  • Lambda/AFR mixture at part load
  • Optimal spark timing/MBT
  • Boost limiter correction for APS/BPS sensor
  • Load / throttle position reference
  • Engine filling management
  • RPM Limiter
  • RPM limiter for LSD
  • Boost pressure linearization
  • Speed limiter
  • Maximum indicated torque
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Relative permissible torque from the pedal position in torque limitation
  • Requested engine filling
  • Variable intake pulsation correction

Firmware-identificatoren (2)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
15515308791037377822 1.16.013 BOSCH ME2.8
15515311791037390710 1.16.013 BOSCH ME2.8

ECU-notities

Original EPROM PSOP 44 pins 29F400BB. In order to read and write this EPROM with the programmer you need the adapter for PSOP and the card 01B with EMP20, or 202B with EMP21. On this epron can be set a KEY.
Original EPROM PSOP 44 pins 29F400BB. This Setting File can be used for serial system NewGenius. ! WARNING ! This ECU is not enabled to be read. Start modification using certified original file from setting file. Attention! If you use the serial system: before start the program, disconnect the feeding on the fans radiator. To work on this ECU you can use NewTrasdata In order to read and write this EPROM with the programmer you need the adapter for PSOP and the card 01B with EMP20, or 202B with EMP21. On this epron can be set a KEY.