Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.
✓ Tuning via bestand (flash)
✓ Aanvullende module beschikbaar 2 firmwareversies
Voertuiggegevens
| Merk | GENESIS |
| Model | G80 Mk1 |
| Motor | 3.3L T-GDi 276kW/370HP SIM2K-260 |
| Standaard vermogen | 375 CV / 276 kW |
| Cilinderinhoud | 3300 cc |
| Brandstof | Benzina sovralimentato |
| Voertuigtype | Auto |
ECU
| Fabrikant | CONTINENTAL-SIEMENS-VDO |
| Model | SIM2K-260 |
| Geheugen / EPROM | MICRO ST TRICORE - 32768 - 400000 |
Beschikbare tuning-opties:
- Base timing
- Base timing 2
- Optimal spark timing/MBT
- Desired engine load calculation
- Lambda correction
- Load / throttle position reference
- Exhaust gas temperature
- Factor to correct fuel delivery system
- Engine idle
- High pressure fuel pump setpoint
- High pressure fuel pump setpoint 2
- High pressure fuel pump setpoint 3
- Intake pressure protection
- Torque limiter 2
- Torque limiter 3
- Torque limiter
- Lambda enrichment for components protection
- RPM Limiter
- Lambda reference
- Knock detection factor
- MAF sensor calibration
- Optimal engine moment
- Maximum pressure ratio limit depending on temperature
- Pop/blow off valve offset - close model
- Pop/blow off valve offset - open model
- Driver torque request
- Setpoint maximum turbocharger speed
- Throttle angle management
- Torque limit table for EOT sensor
- Torque limit table for ECT sensor
- Wastegate duty-cycle
Firmware-identificatoren (2)
| Hardware-nr. | Software-nr. (chip) | Versie | Update-software | ECU |
|---|
| A2C3982360001 | E6W248E1 |
1.96.016 | DHKN3TM__F0B |
CONTINENTAL-SIEMENS-VDO SIM2K-260 |
| A2C3982360001 | E6W248E1 |
1.96.016 | DHHS3TM__B3A |
CONTINENTAL-SIEMENS-VDO SIM2K-260 |
Technische voertuignotities
OBD located to the left of the driver's side, accessible without removing anything to the left of the pedalboard.
ECU-notities
EPROM AM29BDD160G / S29CD016G PQFQ 80 Pin - Microprocessor MPC 563/4 This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata
Aanvullende modules beschikbaar
A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):
Verkrijg het bestand voor dit voertuig
Tools om deze ECU te lezen en schrijven
