FORD FOCUS Mk4 1.0L 16V Ecoboost 74kW/99HP MG1CS016

ECU BOSCH MG1CS016 · 101 CV (74 kW) · 1000 cc · Benzina sovralimentato

ECU-databaseFORD › FORD FOCUS Mk4 1.0L 16V Ecoboost 74kW/99HP MG1CS016

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) ✓ Aanvullende module beschikbaar 4 firmwareversies

Voertuiggegevens

MerkFORD
ModelFOCUS Mk4
Motor1.0L 16V Ecoboost 74kW/99HP MG1CS016
Standaard vermogen101 CV / 74 kW
Cilinderinhoud1000 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelMG1CS016
Geheugen / EPROMMicro Infineon TRICORE categoria AURIX. Il micro ha una DFLASH da 384Kbyte

Beschikbare tuning-opties:

  • Base timing
  • Max threshold air mass flow throught compressor
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Part pedal combustion load limit
  • Compressor pressure ratio limit for pumping and speed
  • Engine indicated torque at stoichiometric
  • Lambda enrichment - open loop
  • Max desired pressure ratio limit
  • Lambda driver wish
  • Lambda driver wish 2
  • Knock detection factor
  • Load limit at high effectiveness of LSPI mitigation
  • Load limit at low effectiveness of LSPI mitigation
  • Load limit at nominal effectiveness of LSPI mitigation
  • Maximum advance allowed
  • Intake manifold pressure
  • Maximum indicated torque
  • Maximum indicated torque for monitoring
  • Maximum indicated torque (overboost active)
  • Minimum indicated torque for monitoring
  • Max load
  • Max load at WOT
  • Maximum intake manifold pressure
  • Maximum throttle angle opening for a given RPM
  • Overall LSPI load limit
  • Percent accelerator pedal angle to desired throttle angle
  • Pressure ratio limit for overboost detection
  • Driver torque request for the transmission - 1st gear
  • Driver torque request for the transmission - 2th gear
  • Driver torque request for the transmission - 3th gear
  • Driver torque request for the transmission - 4th gear
  • Driver torque request for the transmission - 5th gear
  • Driver torque request for the transmission - 6th gear
  • Torque limiter for the 1st gear selected
  • Torque limiter for the 2nd gear selected
  • Torque limiter for the 3rd gear selected
  • Torque limiter for the 4th gear selected
  • Torque limiter for the 5th gear selected
  • Torque limiter for the 6th gear selected
  • Max torque limitation in Neutral (N)
  • Torque limiter for for reverse gear
  • Max torque limitation with trailer - MT
  • Wastegate duty-cycle
  • Max tip at wastegate

Firmware-identificatoren (4)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
JX6A-12B684-KAJX6A-12A650-BJA 1.94.007JX6A-14C204-BPJ BOSCH MG1CS016
JX6A-12B684-KAJX6A-12A650-BJA 1.94.004JX6A-14C204-BPL BOSCH MG1CS016
JX6A-12B684-KAJX6A-12A650-BJA 1.94.007JX6A-14C204-BPM BOSCH MG1CS016
JX6A-12B684-KAJX6A-12A650-BJA 1.94.005JX6A-14C204-BPG BOSCH MG1CS016

ECU-notities

Micro Infineon Tricore TC275TP This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata

Aanvullende modules beschikbaar

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

→ See all add-on modules on the shop