Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.
✓ Derinimas failu (flash)
✓ Galimas papildomas modulis 7 programinės įrangos versijos
Transporto priemonės duomenys
| Markė | ABARTH |
| Modelis | 500 NEW 2010 |
| Variklis | 1.4L 16V TJET 99kW/133HP ME17.3.0 |
| Serijinė galia | 135 CV / 99 kW |
| Darbinis tūris | 1400 cc |
| Kuras | Benzina sovralimentato |
| Transporto priemonės tipas | Auto |
ECU
| Gamintojas | BOSCH |
| Modelis | ME17.3.0 |
| Atmintis / EPROM | MICRO ST TRICORE - 12288 Kbit - 180000 |
Galimos derinimo operacijos / parinktys:
- Engine ignition timing versus temperature
- Absolute boost limit
- Maximum air charge for overboost protection with turbocharger fault
- Base timing
- Optimal spark timing/MBT
- Knock correction advance max
- Boost pressure limiter
- Boost limiter correction for APS/BPS sensor
- Desired engine load calculation
- Lambda correction for engine temperature after starting
- Compression ratio for turbocharger protection
- Compression ratio limiting for compressor depending on IAT sensor
- Exhaust gas temperature
- Characteristic line correction factor for pressure ratio for turbocharger overspeed protection
- Turbocharger efficiency correction factor
- Factor to correct fuel delivery system
- Maximum ratio between compressor and turbine power
- Factor for reducing maximum filling
- Advance limiter for component protection 1
- Torque limiter
- Lambda enrichment for components protection
- Lambda correction for exhaust manifold temperature
- RPM Limiter
- RPM limiter 3
- RPM limit for ECT sensor
- RPM limit for EOT sensor
- Lambda driver wish
- Knock detection factor
- Maximum indicated torque
- Lookup table minimum defined efficiency
- Maximum possible engine charge
- Throttle air mass flow calculation
- Manifold absolute pressure time delay
- Characteristic manifold absolute pressure time constant of the LRS
- Max torque profile
- Torque management City mode
- Torque management in Normal mode
- Torque management Sport mode
- Optimal engine moment
- Power control in City mode
- Power Control in Normal mode
- Power Control in Sport mode
- % relative air filling limit depending on IAT
- Driver torque request
- Driver torque request City mode - AT
- Driver torque request Normal mode - AT
- Driver torque request Sport mode - AT
- Driver torque request City mode
- Driver torque request City mode - MT
- Driver torque request Normal mode - MT
- Driver torque request Sport mode - MT
- Driver torque request for reverse gear
- Driver torque request Sport mode
- Torque limiter for selected gear
- Torque limiter for selected gear 2
- Torque limiter for selected gear 3
- Max torque limitation in Neutral (N)
- Torque limiter for for reverse gear
- Throttle angle management
- Torque limiter in recovery mode
- Turbocharger volumetric efficiency
- Wastegate duty-cycle
Programinės įrangos identifikatoriai (7)
| Aparatinės įrangos Nr. | Programinės įrangos Nr. (lustas) | Versija | Atnaujinimo programinė įranga | ECU |
|---|
| — | — |
1.94.013 | — |
BOSCH ME17.3.0 |
| 0261S09298 | 1037545631 |
1.91.009 | — |
BOSCH ME17.3.0 |
| 0261S09298 | 1037554107 |
1.91.011 | — |
BOSCH ME17.3.0 |
| 0261S10424 | 1037540205 |
1.91.087 | — |
BOSCH ME17.3.0 |
| 0261S10424 | 1037554106 |
1.91.008 | — |
BOSCH ME17.3.0 |
| 0261S10424 | 1037544055 |
1.91.022 | — |
BOSCH ME17.3.0 |
| 0261S10424 | 1037554805 |
1.91.009 | — |
BOSCH ME17.3.0 |
Techninės pastabos apie automobilį
OBD located to the left of the driver's side, under the steering column and behind the bulkhead or the lid in the fuse box area.
ECU pastabos
Microprocessor ST10F275 This Setting File can be used for serial system : Genius or NewGenius. To work on this ECU you can use NewTrasdata WARNING:decrease the values in order to increase Boost (BS) and Overboost (TB).
Microprocessor TC1724 To work on this ECU you can use NewTrasdata
Gaukite failą šiai transporto priemonei
Tools to read and write this ECU
