VOLKSWAGEN JETTA 6 (A6) 2.0L 16V TFSI 147kW/197HP MED17.1

ECU BOSCH MED17.1 · 200 CV (147 kW) · 2000 cc · Benzina sovralimentato

ECU 数据库VOLKSWAGEN › VOLKSWAGEN JETTA 6 (A6) 2.0L 16V TFSI 147kW/197HP MED17.1

查找固件标识(硬件、软件和升级编号)、可用的调校选项,以及如何获取原始或改写文件。

✓ 通过文件调校 (flash) 1 固件版本

车辆数据

品牌VOLKSWAGEN
型号JETTA 6 (A6)
发动机2.0L 16V TFSI 147kW/197HP MED17.1
原厂功率200 CV / 147 kW
排量2000 cc
燃料Benzina sovralimentato
车辆类型Auto

ECU

制造商BOSCH
型号MED17.1
存储 / EPROMMICRO ST TRICORE - 16384 Kbit - 200000

可用的调校选项:

  • Engine ignition timing versus temperature
  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Height correction for boost pressure
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Maximum pressure ratio limit for diagnosis
  • Exhaust gas temperature
  • Factor to correct fuel delivery system
  • Filling factor limit
  • Filling factor limit 2
  • Factor for reducing maximum filling
  • High pressure fuel pump setpoint
  • High fuel pressure pump limit for ECT sensor
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM Limiter 2
  • RPM limiter 3
  • Engine speed limitation at high motor temperature
  • Engine speed limit temperature based
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Maximum boost pressure load
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Optimal engine moment
  • Power limit torque table
  • Relative permissible torque from the pedal position in torque limitation
  • Relative permissible torque from the pedal position in torque limitation 2
  • Pressure ratio depending on IAT
  • Maximum pressure ratio limit depending on temperature
  • Driver torque request
  • Throttle angle management

固件标识 (1)

硬件号软件号 (chip)版本升级软件ECU
1.94.0021K0907115AT 0010 BOSCH MED17.1

ECU 说明

MICRO Infineon Tricore TC1796 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata