VOLKSWAGEN JETTA 6 (A6) 1.8L 16V TSI 125kW/168HP SIMOS12

ECU CONTINENTAL-SIEMENS-VDO SIMOS 12.x · 170 CV (125 kW) · 1800 cc · Benzina sovralimentato

ECU 数据库VOLKSWAGEN › VOLKSWAGEN JETTA 6 (A6) 1.8L 16V TSI 125kW/168HP SIMOS12

查找固件标识(硬件、软件和升级编号)、可用的调校选项,以及如何获取原始或改写文件。

✓ 通过文件调校 (flash) 5 固件版本

车辆数据

品牌VOLKSWAGEN
型号JETTA 6 (A6)
发动机1.8L 16V TSI 125kW/168HP SIMOS12
原厂功率170 CV / 125 kW
排量1800 cc
燃料Benzina sovralimentato
车辆类型Auto

ECU

制造商CONTINENTAL-SIEMENS-VDO
型号SIMOS 12.x
存储 / EPROMMICRO ST TRICORE - 32768 Kbit - 400000

可用的调校选项:

  • Base timing
  • Base timing 2
  • Lambda/AFR full load/WOT
  • Advance correction for IAT sensor
  • Desired engine load calculation - high port flap position
  • Lambda correction
  • Maximum torque limitation at clutch
  • Gearbox maximum torque allowed
  • High pressure fuel pump setpoint
  • Intake pressure protection
  • Torque limiter
  • RPM Limiter
  • Lambda reference
  • Knock detection factor
  • Max torque profile - AT
  • Max torque profile - MT
  • Optimal engine moment
  • Optimal engine moment 2
  • Maximum pressure ratio limit depending on temperature
  • Pop/blow off valve offset - close model
  • Pop/blow off valve offset - open model
  • Driver torque request
  • Driver torque request for high speed
  • Driver torque request for high speed Sport mode - AT
  • Driver torque request for high speed - AT
  • Driver torque request for high speed - MT
  • Driver torque request for high speed in Sport mode
  • Driver torque request for low speed
  • Driver torque request for low speed in Sport mode - AT
  • Driver torque request for low speed - AT

固件标识 (5)

硬件号软件号 (chip)版本升级软件ECU
1.33.00306K906070D 6864 CONTINENTAL-SIEMENS-VDO SIMOS 12.x
1.33.00906K906070F 6865 CONTINENTAL-SIEMENS-VDO SIMOS 12.x
1.33.00206K906070J 9364 CONTINENTAL-SIEMENS-VDO SIMOS 12.x
1.33.00406K906070D 9361 CONTINENTAL-SIEMENS-VDO SIMOS 12.x
1.33.00506K906070F 9360 CONTINENTAL-SIEMENS-VDO SIMOS 12.x

ECU 说明

MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata