YAMAHA MOTORCYCLES NIKEN 900 23->25 85kW

ECU DENSO Bxx-8591A-xx · 115 CV (85 kW) · 900 cc · Benzina aspirato

ECU-databaseYAMAHA MOTORCYCLES › YAMAHA MOTORCYCLES NIKEN 900 23->25 85kW

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 4 firmwareversies

Voertuiggegevens

MerkYAMAHA MOTORCYCLES
ModelNIKEN 900
Motor23->25 85kW
Standaard vermogen115 CV / 85 kW
Cilinderinhoud900 cc
BrandstofBenzina aspirato
VoertuigtypeMoto

ECU

FabrikantDENSO
ModelBxx-8591A-xx
Geheugen / EPROMMicro RENESAS core RH850

Beschikbare tuning-opties:

  • AFR full load/WOT
  • AFR for IAP
  • AFR for TPS
  • Base timing
  • Optimal spark timing/MBT
  • Advance correction
  • Allowed speed difference between axles - set A
  • Allowed speed difference between axles - set B
  • Allowed speed difference between axles - set C
  • Coil charge time
  • Engine brake
  • Engine idle vs. ECT sensor
  • Rpm threshold fuel cut
  • Rpm threshold fuel cut 2
  • Injection for IAP
  • Injection for TPS
  • RPM Limiter
  • Speed limiter
  • Optimal engine moment
  • Optimal engine moment 2
  • Timing cut period by gear
  • Timing cut
  • Timing cut period
  • Throttle angle limitation
  • Throttle angle management - correction - mode 1
  • TAMCM
  • Throttle angle management - correction - mode 3
  • Throttle angle management - correction - mode 4
  • Throttle angle management - mode 1
  • TAMM
  • Throttle angle management - mode 4
  • Cooling fan activation
  • Engine torque limiter depending on vehicle speed

Firmware-identificatoren (4)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
12594001 1.00.007BFD1_12594001 DENSO Bxx-8591A-xx
12594000 1.00.019BFD1_12594000 DENSO Bxx-8591A-xx
125940C1 1.00.005BFD4_125940C1 DENSO Bxx-8591A-xx
12594041 1.00.008BFD6_12594041 DENSO Bxx-8591A-xx

ECU-notities

Microprocessor R7F701201 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata