YAMAHA MOTORCYCLES MT-07 Tracer 700 25->25 55kW

ECU DENSO Bxx-8591A-xx · 73 CV (54 kW) · 690 cc · Benzina aspirato

ECU-databaseYAMAHA MOTORCYCLES › YAMAHA MOTORCYCLES MT-07 Tracer 700 25->25 55kW

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 2 firmwareversies

Voertuiggegevens

MerkYAMAHA MOTORCYCLES
ModelMT-07 Tracer 700
Motor25->25 55kW
Standaard vermogen73 CV / 54 kW
Cilinderinhoud690 cc
BrandstofBenzina aspirato
VoertuigtypeMoto

ECU

FabrikantDENSO
ModelBxx-8591A-xx
Geheugen / EPROMMicro RENESAS core RH850

Beschikbare tuning-opties:

  • AFR full load/WOT
  • AFR for IAP
  • AFR for TPS
  • Base timing
  • Optimal spark timing/MBT
  • Advance correction
  • Coil charge time
  • Engine idle vs. ECT sensor
  • Rpm threshold fuel cut
  • Rpm threshold fuel cut 2
  • Injection for IAP
  • Injection for TPS
  • RPM Limiter
  • Speed limiter
  • Optimal engine moment
  • Optimal engine moment 2
  • Throttle angle limitation
  • TAMCM
  • Throttle angle management - correction - mode 2
  • Throttle angle management - correction - mode 3
  • Throttle angle management - correction - mode 4
  • TAMM
  • Cooling fan activation
  • Engine torque limiter depending on vehicle speed

Firmware-identificatoren (2)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
129DD000 1.00.005BWM1_129DD000 DENSO Bxx-8591A-xx
129DD040 1.00.006BWM2_129DD040 DENSO Bxx-8591A-xx

ECU-notities

Microprocessor R7F701201 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata ATTENTION - 35kW reduced power version file.
Microprocessor R7F701201 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata