SKODA FABIA Mk3 (NJ) 1.0L L3 12V TSI 70kW/94HP MED17.1.27 — ECU BOSCH MED17.1.27

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) ✓ Aanvullende module beschikbaar 6 firmwareversies

Verkrijg het bestand voor dit voertuig

Koop het bestand (origineel of geremapt)Registreer op mastertuningfile.com en bestel het bestand

Ben je een garage of tuner?

Voertuiggegevens

Merk	SKODA
Model	FABIA Mk3 (NJ)
Motor	1.0L L3 12V TSI 70kW/94HP MED17.1.27
Standaard vermogen	95 CV / 7 kW
Cilinderinhoud	1000 cc
Brandstof	Benzina sovralimentato
Voertuigtype	Auto

ECU

Fabrikant	BOSCH
Model	MED17.1.27
Geheugen / EPROM	MICRO ST TRICORE - 32768 - 400000

Beschikbare tuning-opties:

Maximum air charge for overboost protection with turbocharger fault
Base timing
Optimal spark timing/MBT
Boost pressure limiter
Desired engine load calculation
Lambda correction for engine temperature after starting
Exhaust gas temperature
Factor for reducing maximum filling
Gearbox maximum torque allowed
Lambda enrichment for components protection
Lambda correction for exhaust manifold temperature
RPM Limiter
Lambda driver wish
Knock detection factor
Speed limiter
Maximum compression ratio
Throttle air mass flow calculation
Manifold absolute pressure time delay
Characteristic manifold absolute pressure time constant of the LRS
Max torque profile
Optimal engine moment
Power limit torque table
Relative permissible torque from the pedal position in torque limitation
% relative air filling limit depending on IAT
Driver torque request
Throttle angle management

Firmware-identificatoren (6)

Hardware-nr.	Software-nr. (chip)	Versie	Update-software	ECU
—	—	1.94.007	04C906025P 6201	BOSCH MED17.1.27
—	—	1.94.011	04C906025CP 0211	BOSCH MED17.1.27
—	—	1.94.005	04C906025AR 7721	BOSCH MED17.1.27
—	—	1.94.003	04C906025CA 2404	BOSCH MED17.1.27
—	—	1.94.006	04C906025CA 0789	BOSCH MED17.1.27
—	—	1.94.019	04C906025AR 7057	BOSCH MED17.1.27

ECU-notities

MICRO Infineon Tricore TC1793 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata