PORSCHE CAYENNE (92A) 3.6L V6 24V 309kW/414HP MED17.1.6

ECU BOSCH MED17.1.6 · 420 CV (309 kW) · 3600 cc · Benzina sovralimentato

ECU-databasePORSCHE › PORSCHE CAYENNE (92A) 3.6L V6 24V 309kW/414HP MED17.1.6

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 1 firmwareversies

Voertuiggegevens

MerkPORSCHE
ModelCAYENNE (92A)
Motor3.6L V6 24V 309kW/414HP MED17.1.6
Standaard vermogen420 CV / 309 kW
Cilinderinhoud3600 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelMED17.1.6
Geheugen / EPROMMICRO ST TRICORE - 32768 Kbit - 400000

Beschikbare tuning-opties:

  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor to correct fuel delivery system
  • High pressure fuel pump setpoint
  • High fuel pressure pump limit for ECT sensor
  • Torque limiter
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM/speed limiter 2
  • RPM Limiter 2
  • RPM limiter 3
  • RPM limiter 4
  • RPM Limiter 5
  • Lambda driver wish
  • Knock detection factor
  • MAF sensor calibration
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Optimal engine moment
  • Power limit torque table
  • Relative permissible torque from the pedal position in torque limitation
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Driver torque request 2
  • Torque limiter for selected gear
  • Throttle angle management

Firmware-identificatoren (1)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
1.00.00495860163805 2936 BOSCH MED17.1.6

ECU-notities

MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata