PORSCHE BOXSTER (718) 4.0L SPYDER 309kW/414HP MG1CP007

ECU BOSCH MG1CP007 · 420 CV (309 kW) · 4000 cc · Benzina aspirato

ECU-databasePORSCHE › PORSCHE BOXSTER (718) 4.0L SPYDER 309kW/414HP MG1CP007

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 10 firmwareversies

Voertuiggegevens

MerkPORSCHE
ModelBOXSTER (718)
Motor4.0L SPYDER 309kW/414HP MG1CP007
Standaard vermogen420 CV / 309 kW
Cilinderinhoud4000 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelMG1CP007
Geheugen / EPROMMicro Infineon TRICORE categoria AURIX. Il micro ha una DFLASH da 848 Kbyte

Beschikbare tuning-opties:

  • Base timing
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Torque limiter 2
  • Torque limiter 3
  • Torque limiter
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • Engine speed limit temperature based
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Throttle air mass flow calculation
  • Optimal engine moment
  • Power limit torque table
  • Driver torque request
  • Driver torque request 2
  • Throttle angle management

Firmware-identificatoren (10)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
1.02.007982906033AC 0001 BOSCH MG1CP007
1.02.008982906034T 0002 BOSCH MG1CP007
1.02.004982906033AB 0002 BOSCH MG1CP007
1.02.007982906033AF 0001 BOSCH MG1CP007
1.02.003982906034Q 0001 BOSCH MG1CP007
1.02.003982906034AG 0001 BOSCH MG1CP007
1.02.013982906033T 0001 BOSCH MG1CP007
1.00.009982906033K 0003 BOSCH MG1CP007
1.00.007982906033AA 0001 BOSCH MG1CP007
1.02.007982906033AE 0001 BOSCH MG1CP007

ECU-notities

Micro Infineon Tricore TC299TP WARNING - New Genius with security Dongle: the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata