PORSCHE 997 4.0L GT3 Mk2 368kW/494HP ME7.8.2

ECU BOSCH ME7.8.2 min · 500 CV (368 kW) · 4000 cc · Benzina sovralimentato

ECU-databasePORSCHE › PORSCHE 997 4.0L GT3 Mk2 368kW/494HP ME7.8.2

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) ✓ Aanvullende module beschikbaar 1 firmwareversies

Voertuiggegevens

MerkPORSCHE
Model997
Motor4.0L GT3 Mk2 368kW/494HP ME7.8.2
Standaard vermogen500 CV / 368 kW
Cilinderinhoud4000 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelME7.8.2 min
Geheugen / EPROM29F800 PSOP44 8Mbit - Flash 512K x 16

Beschikbare tuning-opties:

  • Base timing
  • Minimum advance allowed
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor to correct fuel delivery system
  • Factor to correct fuel delivery system 2
  • HFM/HLM air flow high limit
  • HFM/HLM air flow low limit
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • Lambda efficiency
  • RPM Limiter
  • RPM Limiter 2
  • Lambda driver wish
  • Knock detection factor
  • MAF sensor calibration
  • Maximum ignition delay allowed for knock limiter intervention
  • Throttle air mass flow calculation
  • Minimum engine air charge value
  • Number of injections considered for knock limitation
  • Optimal engine moment
  • Offset tolerance depending on permissible torque
  • Relative permissible torque from the pedal position in torque limitation
  • Relative permissible torque from the pedal position in torque limitation - sport/race mode
  • Driver wish
  • Driver torque request
  • Maximum threshold for detecting engine knock - bank 1
  • Maximum threshold for detecting engine knock - bank 2
  • Throttle angle management
  • Variable intake pulsation correction

Firmware-identificatoren (1)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
026120134900419100E520 1.87.01400419100E520F419 BOSCH ME7.8.2 min

ECU-notities

Microprocessor ST10F275 Original EPROM PSOP 44 pins 29F800BB. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. To work on this ECU you can use NewTrasdata This Setting File can be used for serial system NewGenius.

Aanvullende modules beschikbaar

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

→ See all add-on modules on the shop