PEUGEOT RIFTER 1.6L 16V HDI 68kW/91HP EDC17C10

ECU BOSCH EDC17C10 · 92 CV (68 kW) · 1600 cc · Diesel sovralimentato

ECU-databasePEUGEOT › PEUGEOT RIFTER 1.6L 16V HDI 68kW/91HP EDC17C10

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 1 firmwareversies

Voertuiggegevens

MerkPEUGEOT
ModelRIFTER
Motor1.6L 16V HDI 68kW/91HP EDC17C10
Standaard vermogen92 CV / 68 kW
Cilinderinhoud1600 cc
BrandstofDiesel sovralimentato
VoertuigtypeLCV

ECU

FabrikantBOSCH
ModelEDC17C10
Geheugen / EPROMMICRO ST TRICORE - 32768 Kbit - 400000

Beschikbare tuning-opties:

  • Boost pressure limiter
  • Boost pressure limiter 2
  • Maximum engine boost pressure F (atmospheric pressure)
  • Boost pressure
  • Boost pressure 2
  • EGR valve control
  • Exhaust gas temperature
  • Exhaust gas temperature 2
  • Injection opening time related to inj. pressure
  • Torque limiter 2
  • Torque limiter
  • Torque limiter for diagnostic
  • Torque limiter for smoke limitation
  • Specific injection pressure limiter
  • Specific injection pressure limiter 2
  • Specific injection pressure limiter 3
  • Specific injection pressure limiter for EFT sensor
  • Specific injection pressure
  • Specific injection pressure 2
  • Specific injection pressure 3
  • Driver torque request
  • Driver torque request for high speed
  • Driver torque request for low speed
  • Driver torque request at the start
  • Driver torque request for reverse gear
  • Torque limiter for EFT sensor
  • Torque limit table for ECT sensor
  • Torque model - fuel quantity to torque conversion

Firmware-identificatoren (1)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
96660772809666729580 1.94.0049693587280 BOSCH EDC17C10

ECU-notities

MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata