PEUGEOT 207 1.4L 16V 60kW/81HP ME7.4.9

ECU BOSCH ME7.4.5 · 82 CV (6 kW) · 1400 cc · Benzina aspirato

ECU-databasePEUGEOT › PEUGEOT 207 1.4L 16V 60kW/81HP ME7.4.9

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 7 firmwareversies

Voertuiggegevens

MerkPEUGEOT
Model207
Motor1.4L 16V 60kW/81HP ME7.4.9
Standaard vermogen82 CV / 6 kW
Cilinderinhoud1400 cc
BrandstofBenzina aspirato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelME7.4.5
Geheugen / EPROMMICRO ST - 6656 Kbit

Beschikbare tuning-opties:

  • Base timing
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Engine idle vs. ECT sensor
  • Engine idle vs. ECT sensor 2
  • Engine idle vs. ECT sensor 3
  • Injection at idle speed
  • Torque limiter for diagnostic
  • Lambda enrichment for components protection
  • RPM Limiter
  • Lambda driver wish
  • Knock detection factor
  • Throttle air mass flow calculation
  • Max torque profile
  • Optimal engine moment
  • Offset tolerance depending on permissible torque
  • Offset tolerance depending on permissible torque 2
  • Relative permissible torque from the pedal position in torque limitation
  • Driver torque request
  • Throttle angle management
  • Variable intake pulsation correction

Firmware-identificatoren (7)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
0261S067661037511733 1.88.0089667372080 BOSCH ME7.4.5
02612019671037397377 1.88.0039666239580 BOSCH ME7.4.9
0261S047401037501884 1.88.0019665597080 BOSCH ME7.4.9
0261S047401037501884 1.88.0059666688580 BOSCH ME7.4.9
0261S050041037507975 1.88.0069666463680 BOSCH ME7.4.9
0261S058821037507254 1.88.0029666837080 BOSCH ME7.4.9
0261S072761037515702 1.88.0059678194180 BOSCH ME7.4.9

Technische voertuignotities

OBD located to the left of the driver's side, under the steering column and behind the bulkhead or the lid in the fuse box area.

ECU-notities

Microprocessor ST10F275 To work on this ECU you can use NewTrasdata WARNING!! ECU ME7 - IX/CL = injection at full load, decrease the values to enrich the injection This Setting File can be used for serial system : Genius or NewGenius.
Microprocessor ST10F275 This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata WARNING!! ECU ME7 - IX/CL = injection at full load, decrease the values to enrich the injection
Microprocessor ST10F275 To work on this ECU you can use NewTrasdata This Setting File can be used for serial system NewGenius.