FIAT QUBO 1.3L 16V MJET 70kW/94HP MJ8DF/8F2 — ECU MARELLI MJD8F2

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) ✓ Aanvullende module beschikbaar 5 firmwareversies

Verkrijg het bestand voor dit voertuig

Koop het bestand (origineel of geremapt)Registreer op mastertuningfile.com en bestel het bestand

Ben je een garage of tuner?

Voertuiggegevens

Merk	FIAT
Model	QUBO
Motor	1.3L 16V MJET 70kW/94HP MJ8DF/8F2
Standaard vermogen	95 CV / 7 kW
Cilinderinhoud	1300 cc
Brandstof	Diesel sovralimentato
Voertuigtype	LCV

ECU

Fabrikant	MARELLI
Model	MJD8F2
Geheugen / EPROM	MICRO BGA MOTOROLA FRESCALE con Flash interna MPC5565 16384 Kbit - 0x200000

Beschikbare tuning-opties:

Maximum engine boost pressure F (atmospheric pressure)
Boost pressure
Engine efficiency
EGR valve control
Basic torque management at engine cranking
Gearbox maximum torque allowed
Injection period
Injection period 2
Injection opening time related to inj. pressure
Injection opening time related to inj. pressure 2
Max injection limit
L
Torque limiter
Lambda value of the smoke limitation
Max torque profile
Rail pressure threshold for torque limitation
Specific injection pressure
Air mass flow
RPM step reference
Driver torque request
Driver torque request Sport mode
Torque limiter for EFT sensor
Torque limit table for ECT sensor
Take-off torque law in Normal mode
Variable geometry duty cycle limit
Variable geometry duty cycle - steady state
Variable geometry duty cycle - transient state

Firmware-identificatoren (5)

Hardware-nr.	Software-nr. (chip)	Versie	Update-software	ECU
MJ8DFHW00P	9743F587	1.01.022	—	MARELLI MJD8F2
MJ8DFHW00P	9744F292	1.01.011	—	MARELLI MJD8F2
MJ8F3HW10C	254AQ310	1.01.026	—	MARELLI MJD8F2
MJ8F3HW10L	3044Q605	1.01.003	—	MARELLI MJD8F3
MJ8F3HW10L	284AQ610	1.01.012	—	MARELLI MJD8F3

Technische voertuignotities

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU-notities

Microprocessor FMPC 5565 To work on this ECU you can use NewTrasdata This Setting File can be used for serial system NewGenius. ATTENTION: before proceding with any serial operation please read carefully the corresponding protocol serial manual.