Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.
✓ Tuning via bestand (flash)
✓ Aanvullende module beschikbaar 2 firmwareversies
Voertuiggegevens
| Merk | FIAT |
| Model | 500 C (312) |
| Motor | 1.4L 8V 75kW/101HP IAW8GMF |
| Standaard vermogen | 102 CV / 75 kW |
| Cilinderinhoud | 1400 cc |
| Brandstof | Benzina aspirato |
| Voertuigtype | Auto |
ECU
Beschikbare tuning-opties:
- Optimal spark timing/MBT
- Advance at part load
- Advance correction
- Base lambda - cold
- Base Lambda - hot
- Boost pressure limiter
- Electronic throttle control
- Compressor pressure ratio limit for pumping and speed
- Average power effective limitation
- Average torque effective limitation
- Advance limiter
- Basic value setpoint Lambda sensor
- RPM Limiter
- Maximum Upstream pressure in event of Normal boost modality
- Maximum Upstream pressure in event of normal boost modality, Sport mode activated
- Maximum Upstream pressure in event of overboost modality
- Maximum Upstream pressure in event of overboost modality, Sport modality activated
- Max torque profile
- Torque management in Normal mode
- Torque management Sport mode
- Power Control in Normal mode
- Power Control in Sport mode
- Power limit torque table
- Resistant torque table
- Torque limit table for ECT sensor
- Take-off torque law in Normal mode
- Take-off torque law in Normal mode with power control
- Take-off torque law in Sport mode
- Take-off torque law in Sport mode with power control
- Wastegate duty-cycle
Firmware-identificatoren (2)
| Hardware-nr. | Software-nr. (chip) | Versie | Update-software | ECU |
|---|
| MM8GMBHW555 | M340C04 |
1.91.005 | 68083994AD |
MARELLI 8GMB/8GMC/8GMF/8GMW/8GSF/8GSW |
| MM8GMBHW625 | F426F03 |
1.01.013 | 68086110AD |
MARELLI 8GMB/8GMC/8GMF/8GMW/8GSF/8GSW |
Technische voertuignotities
OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.
ECU-notities
Microprocessor FMPC 5565 This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata ATTENTION: before proceding with any serial operation please read carefully the corresponding protocol serial manual.
Verkrijg het bestand voor dit voertuig
Tools om deze ECU te lezen en schrijven
