CASE IH FARMALL 120 C 3.6L 89kW/120HP MD1CS069
ECU BOSCH MD1CS069 · 122 pk (89.5 kW) · 4500 cc · Diesel sovralimentato
Firmware-identificatoren: CEFREQ11_ATI, P_1738 5.3.2, CEFREQ02_A5I, CEFREK12_A5I, P_1738 5.2.2, CEFREY01_A5I, P_1738 6.1.0
Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.
Wat je voor dit voertuig kunt bestellen
Origineel ECU-bestand BOSCH MD1CS069
30 credits
Het standaardbestand voor deze ECU.
Registreer gratis en bestelStage 1-bestand
vanaf 120 credits
Levering binnen 1-2 uur (tijdens werkuren). Levenslange garantie op het bestand.
Registreer gratis en bestelUitschakelingen en opties
Voeg ze toe aan het bestand of bestel ze los.
→ Bekijk de volledige prijslijst
Registreer gratis en bestelZo bestel je: gratis registratie, upload het originele bestand dat uit de ECU is gelezen en kies de dienst. 1 credit = € 1.
Het uitschakelen van emissiesystemen is uitsluitend bedoeld voor wedstrijd- en circuitvoertuigen, niet voor gebruik op de openbare weg.
Voertuiggegevens
| Merk | CASE IH |
| Model | FARMALL |
| Motor | 120 C 3.6L 89kW/120HP MD1CS069 |
| Standaard vermogen | 122 pk / 89.5 kW |
| Cilinderinhoud | 4500 cc |
| Brandstof | Diesel sovralimentato |
| Voertuigtype | Tractor |
ECU
| Fabrikant | BOSCH |
| Model | MD1CS069 |
| Geheugen / EPROM | Micro Infineon TRICORE categoria AURIX. Il micro ha una DFLASH da 848 Kbyte |
→ ECU Bosch MD1CS069: alle voertuigen, firmwarenummers en diensten · Alle ECU-families
Beschikbare tuning-opties:
- Boost pressure limiter
- Boost pressure
- Displacement
- Maximum torque limitation at clutch
- Maximum torque limitation at clutch 2
- Desired fuel quantity map for open loop
- Exhaust gas temperature
- Exhaust gas temperature 2
- Engine reference power at crankshaft
- Max CAT temperature threshold for component protection
- Basic torque management at engine cranking
- Injection period
- Injection period 2
- Injection opening time related to inj. pressure
- Injection mass at high temperature
- Injection mass at low temperature
- Maximum fuel quantity for turbine overspeed prevention
- Injection limit - turbocharger protection
- Max injection limit
- Fuel quantity limitation after cold start
- L
- Torque limiter 3
- Torque limiter
- Torque limiter for diagnostic
- PTO torque limiter
- Torque limiter during particulate filter overloading - pressure
- Lambda value of the smoke limitation
- MAP - limp home mode
- Maximum absolute effective torque
- Maximum indicated torque
- Maximum engine torque at crank shaft
- Maximum engine power
- Max torque profile
- Injection quantity for engine overheating protection
- Injection quantity for engine overheating protection 2
- Pressure control map over pressure regulating valve
- Specific injection pressure limiter
- Specific injection pressure limiter for diagnostics
- Specific injection pressure limiter for EFT sensor
- Specific injection pressure
- Specific injection pressure 2
- Driver torque request at the start
- CAT downstream temperature sensor characterization
- CAT upstream temperature sensor characterization
- DPF downstream temperature sensor characterization
- DPF upstream temperature sensor characterization
- SCR downstream temperature sensor characterization
- SCR upstream temperature sensor characterization
- Turbo upstream temperature sensor characterization
- Torque limiter for for reverse gear
- Torque limiter for EFT sensor
- Torque limiter for EFT sensor 2
- Torque limiter in recovery mode
- Torque limiter in recovery mode 2
- Torque limiter in recovery mode 3
- Torque limiter in recovery mode 4
- Torque limiter in recovery mode 5
- Torque model - torque to fuel quantity conversion
- Torque model - torque to fuel quantity conversion 2
- Torque model for performance limiter
- Torque model with performance limiter stage 1 is active
- Torque model with performance limiter stage 2 active
- Torque model with performance limiter after coldstart 1 active
- Torque model with performance limiter after coldstart 2 active
- Turbocharger volumetric efficiency
Firmware-identificatoren (4)
| Hardware-nr. | Software-nr. (chip) | Versie | Update-software | ECU |
|---|---|---|---|---|
| — | P_1738 5.3.2 | 1.67.005 | CEFREQ11_ATI | BOSCH MD1CS069 |
| — | P_1738 5.3.2 | 1.67.005 | CEFREQ02_A5I | BOSCH MD1CS069 |
| — | P_1738 5.2.2 | 1.67.014 | CEFREK12_A5I | BOSCH MD1CS069 |
| — | P_1738 6.1.0 | 1.67.005 | CEFREY01_A5I | BOSCH MD1CS069 |
ECU-notities
Verkrijg het bestand voor dit voertuig
Tools om deze ECU te lezen en schrijven
Andere CASE IH
8010 10.3L 294kW/400HP MS6.2 MAGNUM MX
240 8.3L 176kW/236HP CM554 MAGNUM MX
270 8.3L 199kW/267HP CM570 CHX
420 12.9L 314kW/428HP MS6.2 AFX
8010 10.3L 334kW/455HP EDC7UC31 AF
2388 8.3L 6L 205kW/276HP CM554 AF
2388 8.3L 6L 220kW/295HP CM850 AFX
7010 9.0L 291kW/390HP EDC7UC31 AFX
8790 16.0L V8 405kW/543HP TEMIC PUMA
165 6.7L 123kW/165HP EDC16C39