CAN-AM/BRP MAVERICK 1000 16->20 75kW
ECU BOSCH ME17.8.5 · 102 CV (75 kW) · 1000 cc · Benzina aspirato
ECU-database ›
CAN-AM/BRP › CAN-AM/BRP MAVERICK 1000 16->20 75kW
Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.
✓ Tuning via bestand (flash)
8 firmwareversies
Verkrijg het bestand voor dit voertuig
Voertuiggegevens
| Merk | CAN-AM/BRP |
| Model | MAVERICK 1000 |
| Motor | 16->20 75kW |
| Standaard vermogen | 102 CV / 75 kW |
| Cilinderinhoud | 1000 cc |
| Brandstof | Benzina aspirato |
| Voertuigtype | Moto |
ECU
| Fabrikant | BOSCH |
| Model | ME17.8.5 |
| Geheugen / EPROM | MICRO ST TRICORE - 12032 Kbit - 178000 |
Beschikbare tuning-opties:
- Base timing
- Lambda/AFR mixture for engine temperature at crancking
- Optimal spark timing/MBT
- Lambda correction for engine temperature after starting
- Expected vehicle speed
- ECT for fan disengagement
- ECT for fan engagement
- Injector scaling - cylinder 1
- Injector scaling - cylinder 2
- Torque limiter
- RPM Limiter
- RPM Limiter 2
- Gear dependent maximum engine speed
- RPM limiter in limp mode
- Maximum limitation Lambda sensor
- Speed limiter based on gear
- Speed limiter for key
- Speed limiter - rear axle protection
- Speed limiter for unknown gear
- Map sensor offset
- MAP sensor slope
- Max MAP sensor voltage
- Throttle air mass flow calculation
- Min MAP sensor voltage
- Max allowed torque for speed limit control
- RPM hysteresis above rev limit for fuel cut-off
- Torque limit table for IAT sensor
- Torque limit for voltage
- Target Lambda for knock protection
- Torque limit table for ECT sensor
- Volumetric efficiency
- RPM threshold for 2 foot
- Vehicle speed threshold for 2 foot
Firmware-identificatoren (8)
| Hardware-nr. | Software-nr. (chip) | Versie | Update-software | ECU |
|---|---|---|---|---|
| F00HM00146 | 7E5122RB2RRS2 | 1.94.013 | — | BOSCH ME17.8.5 |
| F00HM00181 | 7E5131PC9RHS8 | 1.94.021 | — | BOSCH ME17.8.5 |
| F00HM00181 | 7E5131VC5VJSB | 1.94.015 | — | BOSCH ME17.8.5 |
| F00HM00181 | 7E5131VC9VJSB | 1.94.010 | — | BOSCH ME17.8.5 |
| F00HM00181 | 7E5130TC5RHS5 | 1.94.014 | — | BOSCH ME17.8.5 |
| F00HM00196 | 7E5169OH3RAS2 | 1.94.005 | — | BOSCH ME17.8.5 |
| F00HM00196 | 7E5163NF3RAS5 | 1.94.008 | — | BOSCH ME17.8.5 |
| F00HM00196 | 7E5169OF3RAS1 | 1.94.012 | — | BOSCH ME17.8.5 |
ECU-notities
MICRO Infineon Tricore TC1766 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
