BMW 3 SERIES F30/F31/F35 320i 2.0L L4 16V 135kW/181HP MEVD17.2.4

ECU BOSCH MEVD17.2.4 · 184 CV (135 kW) · 2000 cc · Benzina sovralimentato

ECU-databaseBMW › BMW 3 SERIES F30/F31/F35 320i 2.0L L4 16V 135kW/181HP MEVD17.2.4

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) ✓ Aanvullende module beschikbaar 27 firmwareversies

Voertuiggegevens

MerkBMW
Model3 SERIES F30/F31/F35
Motor320i 2.0L L4 16V 135kW/181HP MEVD17.2.4
Standaard vermogen184 CV / 135 kW
Cilinderinhoud2000 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelMEVD17.2.4
Geheugen / EPROMMICRO ST TRICORE - 32768 Kbit - 400000

Beschikbare tuning-opties:

  • Base timing
  • Optimal spark timing/MBT
  • Boost pressure
  • Boost pressure 2
  • Desired engine load calculation
  • Maximum torque limitation at clutch
  • Characteristic line correction factor for pressure ratio for turbocharger overspeed protection
  • Gearbox maximum torque allowed
  • HFM/HLM threshold for diagnosis
  • High pressure fuel pump setpoint
  • Intake valve lift
  • Intake valve lift - full load
  • L
  • Torque limiter 4
  • Torque limiter for diagnostic
  • Lambda enrichment for components protection
  • RPM Limiter
  • RPM Limiter 2
  • RPM limit for ECT sensor
  • Boost pressure linearization
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Optimal engine moment
  • Pressure ratio depending on IAT
  • Maximum pressure ratio limit depending on temperature
  • Maximum pressure ratio limit depending on ECT
  • Requested engine filling
  • Driver torque request
  • Wastegate duty-cycle

Firmware-identificatoren (27)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
00000ABD0327010000113D3B7801 1.98.006000013BD3B780E BOSCH MEVD17.2.4
0000124303270100000ABF3BA001 1.98.009000013B93BA002 BOSCH MEVD17.2.4
0000124303270100000ABF3B5001 1.98.004000013AD3B5004 BOSCH MEVD17.2.4
0000124303270100000ABF3B9601 1.98.013000013AD3B9606 BOSCH MEVD17.2.4
0000124303270100000ABF3B8201 1.98.017000019A03B8205 BOSCH MEVD17.2.4
0000124303270100000ABF3BA001 1.98.003000019A03BA001 BOSCH MEVD17.2.4
0000124303270100000ABF3BA001 1.98.002000013B53BA002 BOSCH MEVD17.2.4
0000124303270100000ABF3BA001 1.98.005000013B93BA002 BOSCH MEVD17.2.4
0000124303270100000ABF3B8201 1.98.016000013AD3B820E BOSCH MEVD17.2.4
0000124303270100000ABF3B8201 1.98.004000013B93B8205 BOSCH MEVD17.2.4
0000124303270100000ABF3BA001 1.98.003000013B93BA001 BOSCH MEVD17.2.4
0000124303270100000ABF3B6E03 1.98.004000019A03B6E07 BOSCH MEVD17.2.4
0000124303270100000ABF3BA001 1.98.025000013AD3BA002 BOSCH MEVD17.2.4
0000124303270100000ABF3B6E03 1.98.018000013AD3B6E07 BOSCH MEVD17.2.4
0000124303270100000ABF3B9101 1.98.010000019A03B9103 BOSCH MEVD17.2.4
0000124303270100000ABF3B6E03 1.98.003000013AD3B6E06 BOSCH MEVD17.2.4
0000124303270100000ABF3BA001 1.98.011000013AD3BA001 BOSCH MEVD17.2.4
0000124303270100000ABF3B6E02 1.98.006000013AD3B6E07 BOSCH MEVD17.2.4
0000124303270100000ABF3B9601 1.98.006000013AD3B9604 BOSCH MEVD17.2.4
0000124303270100000ABF3B8201 1.98.004000013AF3B820E BOSCH MEVD17.2.4
0000124303270100000ABF3B9601 1.98.012000013AD3B9601 BOSCH MEVD17.2.4
0000124303270100000ABF3B6E02 1.98.005000013AD3B6E04 BOSCH MEVD17.2.4
0000124303270100000ABF3B8C01 1.98.004000013AD3B8C01 BOSCH MEVD17.2.4
0000124303270100000ABF3B8C01 1.98.015000019A03B8C01 BOSCH MEVD17.2.4
0000124303270100000ABF3B9601 1.98.003000013B53B9604 BOSCH MEVD17.2.4
0000124303270100000ABF3B9101 1.98.016000013AD3B9103 BOSCH MEVD17.2.4
0000124303270100000ABF3B9101 1.98.014000013AD3B9102 BOSCH MEVD17.2.4

Technische voertuignotities

OBD located to the left of the driver's side, in the bulkhead close to the bonnet release lever.

ECU-notities

MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata

Aanvullende modules beschikbaar

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

→ See all add-on modules on the shop