BMW 2 SERIES F22/F23/F44/F45/F46 220i 2.0L L4 16V 135kW/181HP MEVD17.2.9

ECU BOSCH MEVD17.2.9 · 184 CV (135 kW) · 2000 cc · Benzina sovralimentato

ECU-databaseBMW › BMW 2 SERIES F22/F23/F44/F45/F46 220i 2.0L L4 16V 135kW/181HP MEVD17.2.9

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) ✓ Aanvullende module beschikbaar 27 firmwareversies

Voertuiggegevens

MerkBMW
Model2 SERIES F22/F23/F44/F45/F46
Motor220i 2.0L L4 16V 135kW/181HP MEVD17.2.9
Standaard vermogen184 CV / 135 kW
Cilinderinhoud2000 cc
BrandstofBenzina sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelMEVD17.2.9
Geheugen / EPROMMICRO ST TRICORE - 32768 Kbit - 400000

Beschikbare tuning-opties:

  • Base timing
  • Base timing 2
  • Optimal spark timing/MBT
  • Boost pressure
  • Boost pressure 2
  • Desired engine load calculation
  • Maximum torque limitation at clutch
  • Characteristic line correction factor for pressure ratio for turbocharger overspeed protection
  • Gearbox maximum torque allowed
  • HFM/HLM threshold for diagnosis
  • High pressure fuel pump setpoint
  • Intake valve lift
  • Intake valve lift - full load
  • Torque limiter 2
  • L
  • Torque limiter for diagnostic
  • Lambda enrichment for components protection
  • RPM Limiter
  • RPM Limiter 2
  • RPM limit for ECT sensor
  • Boost pressure linearization
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Speed limiter 3
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Optimal engine moment
  • Pressure ratio depending on IAT
  • Maximum pressure ratio limit depending on temperature
  • Maximum pressure ratio limit depending on ECT
  • Requested engine filling
  • Driver torque request
  • Wastegate duty-cycle

Firmware-identificatoren (27)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
000018FF01310100001BC91D6E02 1.98.00400001CEF1D6E09 BOSCH MEVD17.2.9
0000190101270100001C9F1D4B01 1.98.00500001D2B1D4B02 BOSCH MEVD17.2.9
0000190101270100001C9F1D4B01 1.98.01000001D2B1D4C03 BOSCH MEVD17.2.9
0000190101270100001C9F1D4D01 1.98.00400001D2D1D4D01 BOSCH MEVD17.2.9
0000190101270100001C9F1D4B01 1.98.0030000201E1D4B02 BOSCH MEVD17.2.9
0000190101270100001C9F1D4D01 1.98.01200001D2B1D4D01 BOSCH MEVD17.2.9
0000190101310100001C9F1D8201 1.94.004000022C51D8207 BOSCH MEVD17.2.9
0000190101310100001C9F1D6E02 1.98.00700001D2B1D6E03 BOSCH MEVD17.2.9
0000190101310100001C9F1D8201 1.94.00900001D2B1D8205 BOSCH MEVD17.2.9
0000190101310100001C9F1D8201 1.94.012000024B51D8205 BOSCH MEVD17.2.9
0000190101310100001C9F1D8201 1.94.002000024AF1D8207 BOSCH MEVD17.2.9
0000190101310100001C9F1D6E02 1.94.00500001D2B1D6E0C BOSCH MEVD17.2.9
0000190101310100001C9F1D8201 1.94.01100001D2B1D8203 BOSCH MEVD17.2.9
0000190101310100001C9F1D8201 1.94.00600001D2D1D8203 BOSCH MEVD17.2.9
0000190101310100001C9F1D6402 1.98.00900001D2B1D6407 BOSCH MEVD17.2.9
0000190101310100001C9F1D6E02 1.94.00500001D2B1D6E0F BOSCH MEVD17.2.9
0000190101310100001C9F1D6402 1.98.02100001D2B1D6402 BOSCH MEVD17.2.9
0000190101310100001C9F1D8201 1.94.003000024AF1D8205 BOSCH MEVD17.2.9
0000190101310100001C9F1D6E02 1.94.005000024AF1D6E0F BOSCH MEVD17.2.9
0000190101310100001C9F1D6E02 1.94.004000024AF1D6E0C BOSCH MEVD17.2.9
0000190101310100001C9F1D8201 1.94.003000024B51D8203 BOSCH MEVD17.2.9
0000190101310100001C9F1D8201 1.94.01400001D2B1D8209 BOSCH MEVD17.2.9
0000190101310100001C9F1D8201 1.94.00600001D2B1D820D BOSCH MEVD17.2.9
0000190101310200001C9F1D9601 1.94.00400001D2B1D9603 BOSCH MEVD17.2.9
0000190101310200001C9F1D9601 1.94.005000024AF1D9603 BOSCH MEVD17.2.9
0000190101310200001C9F1D9601 1.94.0040000201E1D9603 BOSCH MEVD17.2.9
0000190101310200001C9F1D9601 1.94.00300001D2B1D9607 BOSCH MEVD17.2.9

Technische voertuignotities

OBD located to the left of the driver's side, in the bulkhead close to the bonnet release lever.

ECU-notities

MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata

Aanvullende modules beschikbaar

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

→ See all add-on modules on the shop