AUDI S3 (8Y) 2.0L 16V L4 TFSI 228kW/306HP SIMOS 19.6 — ECU CONTINENTAL-SIEMENS-VDO SIMOS 19.6

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) ✓ Aanvullende module beschikbaar 2 firmwareversies

Verkrijg het bestand voor dit voertuig

Koop het bestand (origineel of geremapt)Registreer op mastertuningfile.com en bestel het bestand

Voertuiggegevens

Merk	AUDI
Model	S3 (8Y)
Motor	2.0L 16V L4 TFSI 228kW/306HP SIMOS 19.6
Standaard vermogen	310 CV / 228 kW
Cilinderinhoud	2000 cc
Brandstof	Benzina sovralimentato
Voertuigtype	Auto

ECU

Fabrikant	CONTINENTAL-SIEMENS-VDO
Model	SIMOS 19.6
Geheugen / EPROM	Micro Infineon TRICORE categoria AURIX. Il micro ha una DFLASH da 848 Kbite

Beschikbare tuning-opties:

Base timing
Main injection start angle
Minimum advance allowed
Optimal spark timing/MBT
Knock correction advance max
Advance correction for IAT sensor
Boost pressure limiter
Boost pressure limiter 2
Desired engine load calculation - high port flap position
Desired engine load calculation - low port flap position
Lambda correction
Maximum torque limitation at clutch
Maximum torque limitation at clutch - MT
Maximum torque limitation at clutch - MT 4WD
Temperature protection for catalyst overheating
Driver torque limit for clutch protection
Torque request at clutch
Exhaust gas temperature
Engine bottom speed limit for upstream throttle leakage
Engine speed top limit for upstream throttle leakage
Positive error threshold for control fault map
Engine torque reducing factor in case of error for torque power limitations
Engine torque reducing factor depending on temperature
L
Torque limiter 3
Torque limiter 4
Torque limiter 5
Basic value setpoint Lambda sensor
Basic value Lambda sensor
Boost pressure deviation limits for basic charge air pressure
Torque limiter
Torque limiter in Eco mode
Lambda minimum value for components protection
Lambda minimum value for components protection 2
RPM limiter - N
Lambda reference
Minimum engine speed for basic charge air pressure too low
Minimum engine speed for basic charge air pressure too low 2
Driver torque request limiter
Knock detection factor
Speed limiter
Maximum charge air pressure for pressure too high
MAP - full load
Manifold pressure manual setpoint
Manifold pressure manual setpoint limit
Maximum throttle angle opening for a given RPM
Max torque profile
Minimum torque for turbo protection
Engine moment management - high port flap position
Engine moment management - low port flap position
Reduction of maximum indicated torque
Driver torque request
Compressor surge line definition
Setpoint maximum turbocharger speed
Setpoint maximum turbocharger speed - turbocharger protection
Head temperature control setpoint
Head temperature control setpoint - IAT
Head temperature control setpoint - ignition angle reduction
Head temperature control setpoint - TOT
Head temperature control setpoint - TOT AT
Head temperature control setpoint - vehicle speed
Torque limitation - turbocharger protection
Temperature difference for turbine protection
Variable camshaft timing

Firmware-identificatoren (2)

Hardware-nr.	Software-nr. (chip)	Versie	Update-software	ECU
—	—	1.33.020	8Y0906259 0003	CONTINENTAL-SIEMENS-VDO SIMOS 19.6
—	—	1.33.014	8Y0906259J 0003	CONTINENTAL-SIEMENS-VDO SIMOS 19.6

Technische voertuignotities

ECU located in the engine bay behind/close to the battery. Difficulty: easy

OBD located to the left of the driver's side, accessible without removing anything to the left of the pedalboard.

ECU-notities

Microprocessor TC297TP_128 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation.