AUDI S3 (8L) 1.8L TURBO 155kW/208HP ME7.5 — ECU BOSCH ME7.5

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) 15 firmwareversies

Verkrijg het bestand voor dit voertuig

Koop het bestand (origineel of geremapt)Registreer op mastertuningfile.com en bestel het bestand

Ben je een garage of tuner?

Voertuiggegevens

Merk	AUDI
Model	S3 (8L)
Motor	1.8L TURBO 155kW/208HP ME7.5
Standaard vermogen	211 CV / 155 kW
Cilinderinhoud	1800 cc
Brandstof	Benzina sovralimentato
Voertuigtype	Auto

ECU

Fabrikant	BOSCH
Model	ME7.5
Geheugen / EPROM	29F400 PSOP44 4Mbit - Flash 256K x 16

Beschikbare tuning-opties:

Base timing
Optimal spark timing/MBT
Boost pressure limiter 3
Boost pressure limiter 4
Boost pressure limiter 5
Boost pressure limit control
Desired engine load calculation
Exhaust gas temperature
Lambda enrichment for components protection
RPM Limiter
RPM Limiter 2
Boost pressure linearization
Lambda driver wish
Knock detection factor
Speed limiter
Maximum boost pressure load
Throttle air mass flow calculation
Manifold absolute pressure time delay
Characteristic manifold absolute pressure time constant of the LRS
Optimal engine moment
Offset tolerance depending on permissible torque
Relative permissible torque from the pedal position in torque limitation
Maximum pressure ratio limit depending on temperature
Driver torque request
Driver torque request Sport mode
Throttle angle management

Firmware-identificatoren (15)

Hardware-nr.	Software-nr. (chip)	Versie	Update-software	ECU
—	—	1.21.041	—	BOSCH ME7.5
0261204900	1037352771	1.21.014	8N0906018 0004	BOSCH ME7.5
0261204900	1037350751	1.21.050	8N0906018 0003	BOSCH ME7.5
0261206442	1037352465	1.21.028	8L0906018K 0004	BOSCH ME7.5
0261206442	1037352049	1.21.042	8L0906018K 0002	BOSCH ME7.5
0261206442	1037352377	1.21.034	8L0906018K 0003	BOSCH ME7.5
0261206442	1037354091	1.21.017	8L0906018K 0005	BOSCH ME7.5
0261206794	1037360284	1.21.042	8N0906018J 0003	BOSCH ME7.5
0261206794	1037360314	1.21.050	8N0906018J 0004	BOSCH ME7.5
0261206794	1037360154	1.21.025	8N0906018J 0001	BOSCH ME7.5
0261206796	1037354092	1.21.048	8L0906018N 0002	BOSCH ME7.5
0261206796	1037352820	1.21.027	8L0906018N 0001	BOSCH ME7.5
0261207213	1037360229	1.21.010	8N0906018AG 0003	BOSCH ME7.5
0261207213	1037354898	1.21.008	8N0906018AG 0001	BOSCH ME7.5
0261207213	1037360320	1.21.022	8N0906018AG 0004	BOSCH ME7.5

Technische voertuignotities

OBD with lid located in the central tunnel, ion the tray between the gear lever and the air conditioning controls.

ECU-notities

Original EPROM PSOP 44 pins 29F400BB. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. On this epron can be set a KEY. ATTENTION !! ME7 ECU ! You can use the emulator ONLY to see the TRACE. MODIFY with the emulator ONLY with the engine OFF; DON'T modify with the engine ON. IX/LCP = INJECTION AT FULL LOAD, DECREASE VALUE TO INCREASE INJECTION! This Setting File can be used for serial system NewGenius. Attention! If you use the serial system: before start the program, disconnect the feeding on the fans radiator.

Original EPROM PSOP 44 pins 29F400BB. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. On this epron can be set a KEY. This Setting File can be used for serial system NewGenius. Attention! If you use the serial system: before start the program, disconnect the feeding on the fans radiator.

Original EPROM PSOP 44 pins 29F800BB. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. On this epron can be set a KEY. ATTENTION !! ME7 ECU ! You can use the emulator ONLY to see the TRACE. MODIFY with the emulator ONLY with the engine OFF; DON'T modify with the engine ON. IX/LCP = INJECTION AT FULL LOAD, DECREASE VALUE TO INCREASE INJECTION! This Setting File can be used for serial system NewGenius. Attention! If you use the serial system: before start the program, disconnect the feeding on the fans radiator.

Original EPROM PSOP 44 pins 29F400. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. On this epron can be set a KEY. ATTENTION !! ME7 ECU ! You can use the emulator ONLY to see the TRACE. MODIFY with the emulator ONLY with the engine OFF; DON'T modify with the engine ON. IX/LCP = INJECTION AT FULL LOAD, DECREASE VALUE TO INCREASE INJECTION!

Verkrijg het bestand voor dit voertuig

Koop het bestand (origineel of geremapt)Registreer op mastertuningfile.com en bestel het bestand Ben je een garage of tuner?Bied deze diensten zelf aan: activeer je TuningFile-platform

Tools om deze ECU te lezen en schrijven

Flex Programmatore per rimappatura centraline e cambi automatici ECU + auto gearbox € 1.000 Kopen

The Genius OBD + Bench € 2.500 Kopen

Andere AUDI

100
2.5L TDI 84kW/113HP 80
1.9L TDI 66kW/88HP A4 (B5/8D)
1.9L 8V TDI 81KW/109HP PLCC A6 (C4/4A)
2.5L 10V TDI 103KW/140HP MOTRONIC 80
2.0L 8V 85kW/114HP S2 (8Z)
2.2L 20V TURBO 162kW/217HP MOTRONIC M2.3 100
2.0L 16V 85kW/114HP MOTRONIC 80
2.0L 16V 103kW/138HP MOTRONIC 80
2.8L V6 24V 128kW/172HP 100
2.0L 8V 74kW/99HP

→ Alle ECU's AUDI