AUDI A6 (C7/4G) 2.0L 16V TFSI 155kW/208HP MED17.1.1 — ECU BOSCH MED17.1.1

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) ✓ Aanvullende module beschikbaar 2 firmwareversies

Verkrijg het bestand voor dit voertuig

Koop het bestand (origineel of geremapt)Registreer op mastertuningfile.com en bestel het bestand

Voertuiggegevens

Merk	AUDI
Model	A6 (C7/4G)
Motor	2.0L 16V TFSI 155kW/208HP MED17.1.1
Standaard vermogen	211 CV / 155 kW
Cilinderinhoud	2000 cc
Brandstof	Benzina sovralimentato
Voertuigtype	Auto

ECU

Fabrikant	BOSCH
Model	MED17.1.1
Geheugen / EPROM	MICRO ST TRICORE - 32768 Kbit - 400000

Beschikbare tuning-opties:

Base timing
Optimal spark timing/MBT
Boost pressure limiter 4
Height correction for boost pressure
Desired engine load calculation
Lambda correction
Desired pressure ratio
Maximum pressure ratio limit for diagnosis
Exhaust gas temperature
High pressure fuel pump setpoint
High fuel pressure pump limit for ECT sensor
Lambda enrichment for components protection
Lambda correction for exhaust manifold temperature
Lambda driver wish
Knock detection factor
Maximum boost pressure load
Throttle air mass flow calculation
Manifold absolute pressure time delay
Characteristic manifold absolute pressure time constant of the LRS
Max torque profile
Max torque profile - AT
Optimal engine moment
Relative permissible torque from the pedal position in torque limitation
Pressure ratio depending on IAT
Driver torque request
Throttle angle management

Firmware-identificatoren (2)

Hardware-nr.	Software-nr. (chip)	Versie	Update-software	ECU
—	—	1.94.003	4G0907115D 0005	BOSCH MED17.1.1
—	—	1.94.014	4G0907115D 0004	BOSCH MED17.1.1

Technische voertuignotities

OBD located to the left of the driver's side, accessible without removing anything to the left of the pedalboard.

ECU-notities

MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata