AUDI A4 (B7/8E/8H) 3.0L V6 24V TDI 171kW/229HP EDC16+

ECU BOSCH EDC16U31/U34/CP34 · 232 CV (171 kW) · 3000 cc · Diesel sovralimentato

ECU-databaseAUDI › AUDI A4 (B7/8E/8H) 3.0L V6 24V TDI 171kW/229HP EDC16+

Vind de firmware-identificatoren (hardware-, software- en updatenummers), beschikbare tuning-opties en hoe je het originele of geremapte bestand krijgt.

✓ Tuning via bestand (flash) ✓ Aanvullende module beschikbaar 26 firmwareversies

Voertuiggegevens

MerkAUDI
ModelA4 (B7/8E/8H)
Motor3.0L V6 24V TDI 171kW/229HP EDC16+
Standaard vermogen232 CV / 171 kW
Cilinderinhoud3000 cc
BrandstofDiesel sovralimentato
VoertuigtypeAuto

ECU

FabrikantBOSCH
ModelEDC16U31/U34/CP34
Geheugen / EPROMAm29BDD160G PQFP80 - Flash 3_V 512 x 32

Beschikbare tuning-opties:

  • Boost pressure limiter
  • Maximum engine boost pressure F (atmospheric pressure)
  • Boost pressure
  • Boost pressure 2
  • Maximum torque limitation at clutch
  • Load / throttle position reference
  • EGR valve control
  • EGR valve control 2
  • Exhaust gas temperature
  • Protection for engine overheating
  • Basic torque management at engine cranking
  • Engine idle vs. ECT sensor
  • Injection period
  • Injection period 2
  • Injection period - correction
  • Injection opening time related to inj. pressure
  • J
  • Injection 2
  • Torque limiter 2
  • Torque limiter 4
  • Lambda value of the smoke limitation
  • Minimum LSU sensor temperature for O2
  • Maximum LSU sensor temperature for O2
  • LSU temperature threshold PID heater governor activation
  • Protection for air load overheating
  • Protection for fuel overheating
  • Protection for oil overheating
  • Specific injection pressure limiter
  • Specific injection pressure
  • Specific air mass charge 2
  • Driver torque request
  • Torque limiter for the 1st gear selected
  • Torque limiter for the 2nd gear selected
  • Torque limiter for the 3rd gear selected
  • Torque limiter for the 4th gear selected
  • Torque limiter for the 5th gear selected
  • Torque limiter for the 6th gear selected
  • Torque limiter for for reverse gear
  • Torque limiter for the APS/BPS
  • Torque limiter in recovery mode
  • Turbocharger volumetric efficiency
  • Variable geometry duty cycle limit
  • Variable geometry duty cycle limit 2

Firmware-identificatoren (26)

Hardware-nr.Software-nr. (chip)VersieUpdate-softwareECU
1037379708 1.67.0238E0910401Q 0030 BOSCH EDC16U31/U34/CP34
1037382431 1.67.0238H0910401A 0050 BOSCH EDC16U31/U34/CP34
1037378837 1.67.0298H0910401A 0020 BOSCH EDC16U31/U34/CP34
1037377114 1.67.0368E0910401E 0030 BOSCH EDC16U31/U34/CP34
1037380224 1.67.0218H0910401A 0040 BOSCH EDC16U31/U34/CP34
10SW084606 1.67.0118E0997402D 0001 BOSCH EDC16U31/U34/CP34
1037379710 1.67.0268E0910401R 0020 BOSCH EDC16U31/U34/CP34
10SW092373 1.67.0188E0997401R 0001 BOSCH EDC16U31/U34/CP34
1037372930 1.67.0238E0910401K 0010 BOSCH EDC16U31/U34/CP34
1037374417 1.67.0328E0910401E 0010 BOSCH EDC16U31/U34/CP34
10SW092380 1.67.0138H0997401B 0001 BOSCH EDC16U31/U34/CP34
1037383300 1.67.0458E0910401P 0050 BOSCH EDC16U31/U34/CP34
10SW092369 1.67.0028E0997402A 0001 BOSCH EDC16U31/U34/CP34
1037382436 1.67.0168E0910401P 0030 BOSCH EDC16U31/U34/CP34
1037374131 1.67.0258E0910401F 0040 BOSCH EDC16U31/U34/CP34
1037382077 1.67.0134E0910402B 0040 BOSCH EDC16U31/U34/CP34
1037383301 1.67.0308H0910401A 0060 BOSCH EDC16U31/U34/CP34
1037379709 1.67.0298E0910401N 0030 BOSCH EDC16U31/U34/CP34
1037374131 1.67.0158E0910401F 0030 BOSCH EDC16U31/U34/CP34
1037376566 1.67.0268E0910401E 0020 BOSCH EDC16U31/U34/CP34
1037377112 1.67.0278E0910401F 0060 BOSCH EDC16U31/U34/CP34
1037382435 1.67.0318E0910401R 0030 BOSCH EDC16U31/U34/CP34
1037379711 1.67.0288E0910401P 0020 BOSCH EDC16U31/U34/CP34
1037382682 1.67.0188E0910401Q 0050 BOSCH EDC16U31/U34/CP34
1037382683 1.67.0288E0910401N 0050 BOSCH EDC16U31/U34/CP34
1037377113 1.67.0238E0910401K 0040 BOSCH EDC16U31/U34/CP34

Technische voertuignotities

OBD located to the left of the driver's side, accessible without removing anything to the left of the pedalboard.

ECU-notities

Original EPROM ST M58BW016DB PQFP 80 Pin - Microprocessor Motorola MPC561/2/3/4. This Setting File can be used for serial system NewGenius. To modify this Ecu you can use the BDM system:555PRO or TRASDATA. WARNING:TRASDATA DO NOT need additional tools, 555PRO instead requires recalculation chks with VAG EDC16 CHECKSUM tool supplied with 555PRO, otherwise you will cause the block of the ecu or the detection of a change in the Ecu through diagnostic tool.
Original EPROM Am29BDD160G PQFP 80 Pin - Microprocessor Motorola MPC56x. This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata

Aanvullende modules beschikbaar

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

→ See all add-on modules on the shop