VOLVO TRUCK BUS B7 TL 7.1L 202kW/271HP LUCAS

ECU LUCAS PLCC 28HC256 · 275 CV (202 kW) · 7100 cc · Diesel sovralimentato

ECU duomenų bazėVOLVO TRUCK › VOLVO TRUCK BUS B7 TL 7.1L 202kW/271HP LUCAS

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) 7 programinės įrangos versijos

Transporto priemonės duomenys

MarkėVOLVO TRUCK
ModelisBUS
VariklisB7 TL 7.1L 202kW/271HP LUCAS
Serijinė galia275 CV / 202 kW
Darbinis tūris7100 cc
KurasDiesel sovralimentato
Transporto priemonės tipasTir

ECU

GamintojasLUCAS
ModelisPLCC 28HC256
Atmintis / EPROM28HC256 PLCC32 256Kbit - EEprom 32K x 8

Galimos derinimo operacijos / parinktys:

  • Injection at idle speed
  • Injection at part load
  • Injection at full throttle
  • Torque limiter 2
  • Torque limiter
  • Smoke limiter at idle speed
  • Smoke limiter at part load
  • Smoke limiter at full throttle

Programinės įrangos identifikatoriai (7)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
03161963XXXX3794 1.55.001 LUCAS PLCC 28HC256
20412507XXXX3620 1.55.002 LUCAS PLCC 28HC256
20412507XXXX3619 1.55.001 LUCAS PLCC 28HC256
20577132XXXX4241 1.55.008 LUCAS PLCC 28HC256
20577132XXXX3794 1.55.001 LUCAS PLCC 28HC256
20577132XXXX5888 1.55.003 LUCAS PLCC 28HC256
20577132XXXX3792 1.55.005 LUCAS PLCC 28HC256

ECU pastabos

Original EPROM 28HC256 PLCC 32 pins This Setting File can be used for serial system NewGenius. WARNING !! With the eprom programmer EMP21 at first select device, then choose "DEVICE OPTIONS" and then "DISABLE SDP AFTER PROGRAM" (confirm with "OK"). With EMP20 once the eprom has been programmed, select "B" for disable data protection and confirm with "Y". To read this EPROM with the EMP20 programmer you need PD28 adapters. Attention !! The EMP21 instead needs the PD32 adapters. On this epron can be set a KEY.
Original EPROM 28HC256 PLCC 32 pins To read this EPROM with the EMP20 programmer you need PD28 adapters. Attention !! The EMP21 instead needs the PD32 adapters. On this epron can be set a KEY. WARNING !! With the eprom programmer EMP21 at first select device, then choose "DEVICE OPTIONS" and then "DISABLE SDP AFTER PROGRAM" (confirm with "OK"). With EMP20 once the eprom has been programmed, select "B" for disable data protection and confirm with "Y". This Setting File can be used for serial system NewGenius.