VOLKSWAGEN MULTIVAN (T5) 2.0L 16V TFSI 147kW/197HP MED17.1

ECU BOSCH MED17.1 · 200 CV (147 kW) · 2000 cc · Benzina sovralimentato

ECU duomenų bazėVOLKSWAGEN › VOLKSWAGEN MULTIVAN (T5) 2.0L 16V TFSI 147kW/197HP MED17.1

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) 1 programinės įrangos versijos

Transporto priemonės duomenys

MarkėVOLKSWAGEN
ModelisMULTIVAN (T5)
Variklis2.0L 16V TFSI 147kW/197HP MED17.1
Serijinė galia200 CV / 147 kW
Darbinis tūris2000 cc
KurasBenzina sovralimentato
Transporto priemonės tipasLCV

ECU

GamintojasBOSCH
ModelisMED17.1
Atmintis / EPROMMICRO ST TRICORE - 16384 Kbit - 200000

Galimos derinimo operacijos / parinktys:

  • Base timing
  • Optimal spark timing/MBT
  • Height correction for boost pressure
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Maximum pressure ratio limit for diagnosis
  • Exhaust gas temperature
  • Filling factor limit
  • Filling factor limit 2
  • High pressure fuel pump setpoint
  • High fuel pressure pump limit for ECT sensor
  • Lambda enrichment for components protection
  • RPM Limiter
  • RPM Limiter 2
  • RPM limiter 3
  • Engine speed limitation at high motor temperature
  • Engine speed limit temperature based
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Maximum boost pressure load
  • Throttle air mass flow calculation
  • Optimal engine moment
  • Power limit torque table
  • Relative permissible torque from the pedal position in torque limitation
  • Pressure ratio depending on IAT
  • Maximum pressure ratio limit depending on temperature
  • Driver torque request
  • Throttle angle management

Programinės įrangos identifikatoriai (1)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
1.94.00706J906021C 5869 BOSCH MED17.1

ECU pastabos

MICRO Infineon Tricore TC1796 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata