TOYOTA VENZA (AV10) 2.7L L4 136kW/182HP DENSO

ECU DENSO 275036-5810 · 185 CV (136 kW) · 2700 cc · Benzina aspirato

ECU duomenų bazėTOYOTA › TOYOTA VENZA (AV10) 2.7L L4 136kW/182HP DENSO

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) 2 programinės įrangos versijos

Transporto priemonės duomenys

MarkėTOYOTA
ModelisVENZA (AV10)
Variklis2.7L L4 136kW/182HP DENSO
Serijinė galia185 CV / 136 kW
Darbinis tūris2700 cc
KurasBenzina aspirato
Transporto priemonės tipasAuto

ECU

GamintojasDENSO
Modelis275036-5810
Atmintis / EPROMMICRO NEC 76F0085 - 8192 Kbit - 100000

Galimos derinimo operacijos / parinktys:

  • Base timing
  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Advance correction
  • Spark advance correction - valve timing position 1
  • Electronic throttle control
  • Electronic throttle control 2
  • Electronic throttle control 3
  • Lambda correction f(IAT)
  • Lambda correction f(ECT)
  • Lambda correction f(ECT) 2
  • L
  • Advance limiter for component protection 1
  • Basic value setpoint Lambda sensor
  • Torque limiter
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Exhaust gas temperature sensor
  • Exhaust gas temperature sensor 3
  • Variable valve timing - inlet
  • Variable valve timing - outlet

Programinės įrangos identifikatoriai (2)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
89663-0T070- 1.51.00730T07000 DENSO 275036-5810
89663-0T071- 1.51.00930T07100 DENSO 275036-5810

ECU pastabos

Microprocessor NEC 76F0085 This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata