TOYOTA RAV4 (XA30) 3.5L V6 24V VVT-i 200kW/268HP DENSO

ECU DENSO 275036-2110 · 272 CV (2 kW) · 3500 cc · Benzina aspirato

ECU duomenų bazėTOYOTA › TOYOTA RAV4 (XA30) 3.5L V6 24V VVT-i 200kW/268HP DENSO

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) 3 programinės įrangos versijos

Transporto priemonės duomenys

MarkėTOYOTA
ModelisRAV4 (XA30)
Variklis3.5L V6 24V VVT-i 200kW/268HP DENSO
Serijinė galia272 CV / 2 kW
Darbinis tūris3500 cc
KurasBenzina aspirato
Transporto priemonės tipasAuto

ECU

GamintojasDENSO
Modelis275036-2110
Atmintis / EPROMMICRO NEC 76F0038AGD - 6144 Kbit - C0000

Galimos derinimo operacijos / parinktys:

  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Spark advance correction - valve timing position 2
  • Electronic throttle control
  • Electronic throttle control 2
  • Electronic throttle control 3
  • Lambda correction f(IAT)
  • Lambda correction f(ECT)
  • Lambda correction f(ECT) 2
  • Lambda correction f(ECT) 3
  • Torque limiter 2
  • Advance limiter for component protection 1
  • Basic value setpoint Lambda sensor
  • Torque limiter
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Exhaust gas temperature sensor
  • Variable valve timing - inlet
  • Variable valve timing - outlet

Programinės įrangos identifikatoriai (3)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
89663-42751- 1.51.00734275100 DENSO 275036-2110
89663-42860- 1.51.02134286000 DENSO 275036-2110
89663-42A30-B 1.51.008342A3000 DENSO 275036-3560

ECU pastabos

Microprocessor NEC 76F0070 This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
Microprocessor NEC 76F0038AGD This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata