TOYOTA LAND CRUISER (J200) 4.5L V8 32V D-4D 162kW/217HP DENSO

ECU DENSO 275922-001 · 220 CV (162 kW) · 4500 cc · Diesel sovralimentato

ECU duomenų bazėTOYOTA › TOYOTA LAND CRUISER (J200) 4.5L V8 32V D-4D 162kW/217HP DENSO

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) 1 programinės įrangos versijos

Transporto priemonės duomenys

MarkėTOYOTA
ModelisLAND CRUISER (J200)
Variklis4.5L V8 32V D-4D 162kW/217HP DENSO
Serijinė galia220 CV / 162 kW
Darbinis tūris4500 cc
KurasDiesel sovralimentato
Transporto priemonės tipasAuto

ECU

GamintojasDENSO
Modelis275922-001
Atmintis / EPROMMICRO NEC 76F0070 - 8192 Kbit - 100000

Galimos derinimo operacijos / parinktys:

  • Boost pressure limiter for diagnostics
  • Boost pressure limiter
  • Boost pressure
  • Boost pressure 2
  • Boost pressure 3
  • Variable boost pressure 1
  • Variable boost pressure 2
  • Injection correction 2
  • Injection opening time related to inj. pressure
  • Injection opening time related to inj. pressure 2
  • Max injection limit
  • Max injection limit 2
  • Max injection limit for APS/BPS sensor
  • Max injection limit - limp mode
  • Injection correction
  • Injection correction for IAT sensor
  • J
  • Speed limiter
  • Maximum possible engine charge
  • Specific injection pressure limiter
  • Specific injection pressure
  • Air mass flow
  • Variable geometry duty cycle limit
  • Variable geometry duty cycle limit 3

Programinės įrangos identifikatoriai (1)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
89663-60B30- 1.67.010360B3000 DENSO 275922-001

Techninės pastabos apie automobilį

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU pastabos

Microprocessor NEC 76F0070 This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata