TOYOTA ETIOS (AK10) 1.5L 16V VVT-i 71kW/96HP DENSO

ECU DENSO 275036-9050 · 97 CV (71 kW) · 1500 cc · Benzina aspirato

ECU duomenų bazėTOYOTA › TOYOTA ETIOS (AK10) 1.5L 16V VVT-i 71kW/96HP DENSO

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) 4 programinės įrangos versijos

Transporto priemonės duomenys

MarkėTOYOTA
ModelisETIOS (AK10)
Variklis1.5L 16V VVT-i 71kW/96HP DENSO
Serijinė galia97 CV / 71 kW
Darbinis tūris1500 cc
KurasBenzina aspirato
Transporto priemonės tipasAuto

ECU

GamintojasDENSO
Modelis275036-9050
Atmintis / EPROMMICRO NEC 76F0039AGD - 512Kbit - 80000

Galimos derinimo operacijos / parinktys:

  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Electronic throttle control
  • Electronic throttle control 2
  • Torque limiter 2
  • Advance limiter for component protection 1
  • Basic value setpoint Lambda sensor
  • Torque limiter
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Driver torque request 2
  • Exhaust gas temperature sensor
  • Exhaust gas temperature sensor 2
  • Exhaust gas temperature sensor 3

Programinės įrangos identifikatoriai (4)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
89663-0DD02- 1.67.03330DD0200 DENSO 275036-9050
89663-0DC81- 1.67.01030DC8100 DENSO 275036-9050
89663-0DD01- 1.67.00530DD0100 DENSO 275036-9050
89663-0DC80- 1.67.00530DC8000 DENSO 275036-9050

Techninės pastabos apie automobilį

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU pastabos

Microprocessor NEC 76F0040GD This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata