SEAT EXEO 2.0L 16V TSI 147kW/197HP MED17.1

ECU BOSCH MED17.1 · 200 CV (147 kW) · 2000 cc · Benzina sovralimentato

ECU duomenų bazėSEAT › SEAT EXEO 2.0L 16V TSI 147kW/197HP MED17.1

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) ✓ Galimas papildomas modulis 1 programinės įrangos versijos

Transporto priemonės duomenys

MarkėSEAT
ModelisEXEO
Variklis2.0L 16V TSI 147kW/197HP MED17.1
Serijinė galia200 CV / 147 kW
Darbinis tūris2000 cc
KurasBenzina sovralimentato
Transporto priemonės tipasAuto

ECU

GamintojasBOSCH
ModelisMED17.1
Atmintis / EPROMMICRO ST TRICORE - 16384 Kbit - 200000

Galimos derinimo operacijos / parinktys:

  • Engine ignition timing versus temperature
  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Height correction for boost pressure
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Maximum pressure ratio limit for diagnosis
  • Exhaust gas temperature
  • Factor to correct fuel delivery system
  • Filling factor limit
  • Filling factor limit 2
  • Factor for reducing maximum filling
  • High pressure fuel pump setpoint
  • High fuel pressure pump limit for ECT sensor
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM Limiter 2
  • RPM limiter 3
  • Engine speed limitation at high motor temperature
  • Engine speed limit temperature based
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Maximum boost pressure load
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Optimal engine moment
  • Power limit torque table
  • Relative permissible torque from the pedal position in torque limitation
  • Relative permissible torque from the pedal position in torque limitation 2
  • Pressure ratio depending on IAT
  • Maximum pressure ratio limit depending on temperature
  • Driver torque request
  • Throttle angle management

Programinės įrangos identifikatoriai (1)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
1.94.0213R0907115J 0020 BOSCH MED17.1

ECU pastabos

MICRO Infineon Tricore TC1796 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata

Galimi papildomi moduliai

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

→ See all add-on modules on the shop