SEAT EXEO 1.8L 20V TFSI 110kW/150HP MED17.5

ECU BOSCH MED17.5 · 150 CV (11 kW) · 1800 cc · Benzina sovralimentato

ECU duomenų bazėSEAT › SEAT EXEO 1.8L 20V TFSI 110kW/150HP MED17.5

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) ✓ Galimas papildomas modulis 1 programinės įrangos versijos

Transporto priemonės duomenys

MarkėSEAT
ModelisEXEO
Variklis1.8L 20V TFSI 110kW/150HP MED17.5
Serijinė galia150 CV / 11 kW
Darbinis tūris1800 cc
KurasBenzina sovralimentato
Transporto priemonės tipasAuto

ECU

GamintojasBOSCH
ModelisMED17.5
Atmintis / EPROMMICRO ST TRICORE - 12032 Kbit - 178000

Galimos derinimo operacijos / parinktys:

  • Base timing
  • Base timing 2
  • Optimal spark timing/MBT
  • Advance correction
  • Height correction for boost pressure
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Maximum pressure ratio limit for diagnosis
  • Exhaust gas temperature
  • Filling factor limit
  • Filling factor limit 2
  • Factor for reducing maximum filling
  • Gearbox maximum torque allowed
  • High pressure fuel pump setpoint
  • High fuel pressure pump limit for ECT sensor
  • High fuel pressure pump limit
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM Limiter 2
  • RPM limiter 3
  • RPM limiter 4
  • RPM Limiter 5
  • RPM limiter - N
  • RPM limiter in Park position
  • RPM limit for ECT sensor
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Maximum boost pressure load
  • Maximum boost pressure load 2
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Maximum negative deviation for boost overcharge
  • Optimal engine moment
  • Power limit torque table
  • Relative permissible torque from the pedal position in torque limitation
  • Relative permissible torque from the pedal position in torque limitation - sport/race mode
  • Pressure ratio depending on IAT
  • Maximum pressure ratio limit depending on temperature
  • Driver torque request
  • Driver torque request AWD
  • Driver torque request for reverse gear
  • Throttle angle management

Programinės įrangos identifikatoriai (1)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
1.94.0203R0907115C 0020 BOSCH MED17.5

ECU pastabos

MICRO Infineon Tricore TC1766 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata

Galimi papildomi moduliai

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

→ See all add-on modules on the shop