SEA-DOO WAKE 1.6L 16V 127kW/170HP ME17.8.5

ECU BOSCH ME17.8.5 · 172 CV (127 kW) · 1630 cc · Benzina aspirato

ECU duomenų bazėSEA-DOO › SEA-DOO WAKE 1.6L 16V 127kW/170HP ME17.8.5

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) 1 programinės įrangos versijos

Transporto priemonės duomenys

MarkėSEA-DOO
ModelisWAKE
Variklis1.6L 16V 127kW/170HP ME17.8.5
Serijinė galia172 CV / 127 kW
Darbinis tūris1630 cc
KurasBenzina aspirato
Transporto priemonės tipasMarine

ECU

GamintojasBOSCH
ModelisME17.8.5
Atmintis / EPROMMICRO ST TRICORE - 12032 Kbit - 178000

Galimos derinimo operacijos / parinktys:

  • Base timing
  • Lambda/AFR mixture for engine temperature at crancking
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Expected vehicle speed
  • ECT for fan disengagement
  • ECT for fan engagement
  • Injector latency - cylinder 1
  • Injector latency - cylinder 2
  • INJSC
  • RPM Limiter
  • RPM Limiter 2
  • Gear dependent maximum engine speed
  • RPM limiter in limp mode
  • Maximum limitation Lambda sensor
  • Speed limiter - rear axle protection
  • Map sensor offset
  • MAP sensor slope
  • Max MAP sensor voltage
  • Throttle air mass flow calculation
  • Min MAP sensor voltage
  • Max allowed torque for speed limit control
  • Optimal engine moment
  • Driver torque request
  • Throttle angle management
  • Target Lambda for knock protection
  • Turbocharger volumetric efficiency

Programinės įrangos identifikatoriai (1)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
F00HM001967A1163QE1FOS1 1.94.002 BOSCH ME17.8.5

ECU pastabos

MICRO Infineon Tricore TC1766 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata