PORSCHE BOXSTER (718) 4.0L GTS 294kW/394HP MG1CP007

ECU BOSCH MG1CP007 · 400 CV (294 kW) · 4000 cc · Benzina aspirato

ECU duomenų bazėPORSCHE › PORSCHE BOXSTER (718) 4.0L GTS 294kW/394HP MG1CP007

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) 5 programinės įrangos versijos

Transporto priemonės duomenys

MarkėPORSCHE
ModelisBOXSTER (718)
Variklis4.0L GTS 294kW/394HP MG1CP007
Serijinė galia400 CV / 294 kW
Darbinis tūris4000 cc
KurasBenzina aspirato
Transporto priemonės tipasAuto

ECU

GamintojasBOSCH
ModelisMG1CP007
Atmintis / EPROMMicro Infineon TRICORE categoria AURIX. Il micro ha una DFLASH da 848 Kbyte

Galimos derinimo operacijos / parinktys:

  • Base timing
  • Base timing 2
  • Optimal spark timing/MBT
  • Optimal spark timing/MBT 2
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Torque limiter 2
  • Torque limiter 3
  • Torque limiter
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • Engine speed limit temperature based
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Optimal engine moment
  • Power limit torque table
  • Driver torque request
  • Throttle angle management

Programinės įrangos identifikatoriai (5)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
1.02.002982906034BH 0001 BOSCH MG1CP007
1.02.003982906034AJ 0001 BOSCH MG1CP007
1.02.002982906034BF 0001 BOSCH MG1CP007
1.02.002982906034BG 0001 BOSCH MG1CP007
1.02.002982906034BE 0001 BOSCH MG1CP007

ECU pastabos

Micro Infineon Tricore TC299TP WARNING - New Genius with security Dongle: the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata