MERCEDES R CLASS W251 R63 AMG 6.2L V8 32V 375kW/503HP ME9.7

ECU BOSCH ME9.7 · 510 CV (375 kW) · 6200 cc · Benzina aspirato

ECU duomenų bazėMERCEDES › MERCEDES R CLASS W251 R63 AMG 6.2L V8 32V 375kW/503HP ME9.7

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) 1 programinės įrangos versijos

Transporto priemonės duomenys

MarkėMERCEDES
ModelisR CLASS W251
VariklisR63 AMG 6.2L V8 32V 375kW/503HP ME9.7
Serijinė galia510 CV / 375 kW
Darbinis tūris6200 cc
KurasBenzina aspirato
Transporto priemonės tipasAuto

ECU

GamintojasBOSCH
ModelisME9.7
Atmintis / EPROMM58BW016DB PQFP80 - Flash 3_V 512 x 32

Galimos derinimo operacijos / parinktys:

  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor to correct fuel delivery system
  • HFM/HLM threshold for diagnosis
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM Limiter 2
  • RPM limit for ECT sensor
  • Knock detection factor
  • Speed limiter
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Throttle angle management
  • Variable intake pulsation correction

Programinės įrangos identifikatoriai (1)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
00444637400044487040 1.79.0190064472440 BOSCH ME9.7

ECU pastabos

Original EPROM ST M58BW016DB PQFP 80 Pin - Microprocessor Motorola MPC561/2/3/4. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata