MERCEDES CLS CLASS C219 CLS500 5.0L V8 225kW/302HP ME2.8

ECU BOSCH ME2.8 · 306 CV (225 kW) · 5000 cc · Benzina aspirato

ECU duomenų bazėMERCEDES › MERCEDES CLS CLASS C219 CLS500 5.0L V8 225kW/302HP ME2.8

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) 4 programinės įrangos versijos

Transporto priemonės duomenys

MarkėMERCEDES
ModelisCLS CLASS C219
VariklisCLS500 5.0L V8 225kW/302HP ME2.8
Serijinė galia306 CV / 225 kW
Darbinis tūris5000 cc
KurasBenzina aspirato
Transporto priemonės tipasAuto

ECU

GamintojasBOSCH
ModelisME2.8
Atmintis / EPROM29F400 PSOP44 4Mbit - Flash 256K x 16

Galimos derinimo operacijos / parinktys:

  • Base timing
  • Lambda/AFR full load/WOT
  • Lambda/AFR mixture at part load
  • Optimal spark timing/MBT
  • Advance at part load
  • Boost limiter correction for APS/BPS sensor
  • Load / throttle position reference
  • RPM Limiter
  • Speed limiter
  • Maximum indicated torque
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Relative permissible torque from the pedal position in torque limitation
  • Requested engine filling
  • Variable intake pulsation correction

Programinės įrangos identifikatoriai (4)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
11315310911037371576 1.16.007 BOSCH ME2.8
11315370791037369472 1.16.007 BOSCH ME2.8
11315386791037365376 1.16.013 BOSCH ME2.8
1131538879103736xxxx 1.16.017 BOSCH ME2.8

ECU pastabos

Original EPROM PSOP 44 pins 29F400BB. This Setting File can be used for serial system NewGenius. ! WARNING ! This ECU is not enabled to be read. Start modification using certified original file from setting file. Attention! If you use the serial system: before start the program, disconnect the feeding on the fans radiator. To work on this ECU you can use NewTrasdata In order to read and write this EPROM with the programmer you need the adapter for PSOP and the card 01B with EMP20, or 202B with EMP21. On this epron can be set a KEY.