LEXUS GX (J150) 460 4.6L V8 221kW/296HP VVT-i DENSO

ECU DENSO 275036-5920 · 300 CV (221 kW) · 4600 cc · Benzina aspirato

ECU duomenų bazėLEXUS › LEXUS GX (J150) 460 4.6L V8 221kW/296HP VVT-i DENSO

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) 2 programinės įrangos versijos

Transporto priemonės duomenys

MarkėLEXUS
ModelisGX (J150)
Variklis460 4.6L V8 221kW/296HP VVT-i DENSO
Serijinė galia300 CV / 221 kW
Darbinis tūris4600 cc
KurasBenzina aspirato
Transporto priemonės tipasAuto

ECU

GamintojasDENSO
Modelis275036-5920
Atmintis / EPROMMICRO NEC 76F0070 - 8192 Kbit - 100000

Galimos derinimo operacijos / parinktys:

  • Base timing
  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Spark advance correction - valve timing position 2
  • Electronic throttle control
  • Electronic throttle control 2
  • Electronic throttle control 3
  • Lambda correction f(IAT)
  • Lambda correction f(IAT) 2
  • Lambda correction f(ECT)
  • Gearbox maximum torque allowed
  • Advance limiter for component protection 1
  • Basic value setpoint Lambda sensor
  • Torque limiter
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Exhaust gas temperature sensor
  • Variable valve timing - inlet
  • Variable valve timing - outlet

Programinės įrangos identifikatoriai (2)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
89663-60K00- 1.67.005360K0000 DENSO 275036-5920
89663-60E74- 1.67.005360E7400 DENSO 275036-5920

ECU pastabos

Microprocessor NEC 76F0070 This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata