KAWASAKI Z 900 RS 22->25 82kW

ECU DENSO 21175-1840/1848/1851 · 111 CV (82 kW) · 948 cc · Benzina aspirato

ECU duomenų bazėKAWASAKI › KAWASAKI Z 900 RS 22->25 82kW

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) 1 programinės įrangos versijos

Transporto priemonės duomenys

MarkėKAWASAKI
ModelisZ 900 RS
Variklis22->25 82kW
Serijinė galia111 CV / 82 kW
Darbinis tūris948 cc
KurasBenzina aspirato
Transporto priemonės tipasMoto

ECU

GamintojasDENSO
Modelis21175-1840/1848/1851
Atmintis / EPROMMicro RENESAS - 8192 Kbit -100000

Galimos derinimo operacijos / parinktys:

  • Base timing - full power
  • Base timing - low power
  • Base timing - clutch/neutral
  • Exhaust valve management in deceleration - gear based - full power
  • Exhaust valve management in deceleration - gear based - low power
  • Exhaust valve management - gear based - full power
  • Exhaust valve management - gear based - low power
  • Engine idle vs. ECT sensor
  • Injection for IAP - full power
  • Injection for IAP - low power
  • Injection for TPS - full power
  • Injection for TPS - low power
  • RPM Limiter
  • RPM Limiter 2
  • RPM limiter - N
  • Secondary throttle plates management in deceleration - gear based - full power
  • Secondary throttle plates management in deceleration - gear based - low power
  • Secondary throttle plates management - gear based - full power
  • Secondary throttle plates management - gear based - low power
  • Cooling fan activation
  • Traction control - activation sensitivity
  • Traction control - slip sensitivity
  • Traction control - TPS correction

Programinės įrangos identifikatoriai (1)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
21175-1840TPP2K8E0 1.00.01149245-2050 DENSO 21175-1840/1848/1851

ECU pastabos

Microprocessor SH7058 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata