KAWASAKI Z 1000 20-> 118kW

ECU DENSO 21175-1363 · 160 CV (118 kW) · 1000 cc · Benzina aspirato

ECU duomenų bazėKAWASAKI › KAWASAKI Z 1000 20-> 118kW

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) 1 programinės įrangos versijos

Transporto priemonės duomenys

MarkėKAWASAKI
ModelisZ 1000
Variklis20-> 118kW
Serijinė galia160 CV / 118 kW
Darbinis tūris1000 cc
KurasBenzina aspirato
Transporto priemonės tipasMoto

ECU

GamintojasDENSO
Modelis21175-1363
Atmintis / EPROMMicro RENESAS - 8192 Kbit -100000

Galimos derinimo operacijos / parinktys:

  • Base timing - full power
  • Base timing - low power
  • Base timing - clutch/neutral
  • Load / throttle position reference
  • Exhaust valve management in deceleration - gear based - full power
  • Exhaust valve management in deceleration - gear based - low power
  • Exhaust valve management - gear based - full power
  • Exhaust valve management - gear based - low power
  • Engine idle vs. ECT sensor
  • Injection for IAP - full power
  • Injection for IAP - low power
  • Injection for TPS - full power
  • Injection for TPS - low power
  • RPM Limiter
  • RPM Limiter 2
  • Ram Air
  • Secondary throttle plates management in deceleration - gear based - full power
  • Secondary throttle plates management in deceleration - gear based - low power
  • Secondary throttle plates management - gear based - full power
  • Secondary throttle plates management - gear based - low power
  • Cooling fan activation
  • Traction control - activation sensitivity
  • Traction control - slip sensitivity
  • Traction control - TPS correction

Programinės įrangos identifikatoriai (1)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
21175-1363KPHPK8H0 1.00.01549245-1321 DENSO 21175-1363

ECU pastabos

Microprocessor SH7058 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata