Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.
✓ Derinimas failu (flash)
2 programinės įrangos versijos
Transporto priemonės duomenys
| Markė | KAWASAKI |
| Modelis | VERSYS 1000 |
| Variklis | 15->18 88kW |
| Serijinė galia | 120 CV / 88 kW |
| Darbinis tūris | 1000 cc |
| Kuras | Benzina aspirato |
| Transporto priemonės tipas | Moto |
ECU
Galimos derinimo operacijos / parinktys:
- Base timing - full power
- Base timing - low power
- Base timing - clutch/neutral
- Load / throttle position reference
- Exhaust valve management in deceleration - gear based - full power
- Exhaust valve management in deceleration - gear based - low power
- Exhaust valve management - gear based - full power
- Exhaust valve management - gear based - low power
- Engine idle vs. ECT sensor
- Injection for IAP - full power
- Injection for IAP - low power
- Injection for TPS - full power
- Injection for TPS - low power
- RPM Limiter
- RPM Limiter 2
- Ram Air
- Secondary throttle plates management in deceleration - gear based - full power
- Secondary throttle plates management in deceleration - gear based - low power
- Secondary throttle plates management - gear based - full power
- Secondary throttle plates management - gear based - low power
- Cooling fan activation
- Traction control - activation sensitivity
- Traction control - slip sensitivity
- Traction control - TPS correction
Programinės įrangos identifikatoriai (2)
| Aparatinės įrangos Nr. | Programinės įrangos Nr. (lustas) | Versija | Atnaujinimo programinė įranga | ECU |
|---|
| 21175-0754 | CPA8KPB1 |
1.00.006 | — |
DENSO 21175-02XX/03XX/07XX/08XX/09XX |
| 21175-1218 | KPHJK9E0 |
1.00.009 | 49245-1113 |
DENSO 21175-1212/1213/1217/1218 |
Techninės pastabos apie automobilį
OBD located under the passenger rear seat
ECU located in the engine bay behind/close to the battery. Difficulty: easy
ECU pastabos
Microprocessor SH7058 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
Microprocessor M32R196 To work on this ECU you can use NewTrasdata
Gaukite failą šiai transporto priemonei
Tools to read and write this ECU
