JAGUAR F-TYPE (X152) 5.0L 32V V8 SC P450 331kW/450HP MED17.8.32

ECU BOSCH MED17.8.32 · 450 CV (331 kW) · 5000 cc · Benzina aspirato

ECU duomenų bazėJAGUAR › JAGUAR F-TYPE (X152) 5.0L 32V V8 SC P450 331kW/450HP MED17.8.32

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) 1 programinės įrangos versijos

Transporto priemonės duomenys

MarkėJAGUAR
ModelisF-TYPE (X152)
Variklis5.0L 32V V8 SC P450 331kW/450HP MED17.8.32
Serijinė galia450 CV / 331 kW
Darbinis tūris5000 cc
KurasBenzina aspirato
Transporto priemonės tipasAuto

ECU

GamintojasBOSCH
ModelisMED17.8.32
Atmintis / EPROMMICRO ST TRICORE - 32768 Kbit - 400000

Galimos derinimo operacijos / parinktys:

  • Base timing
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Average power effective limitation
  • Gearbox maximum torque allowed
  • High pressure fuel pump setpoint
  • High pressure fuel pump setpoint 2
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM limit for ECT sensor
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Maximum indicated torque
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • Maximum pressure ratio limit depending on ECT
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Torque limiter for selected gear
  • Throttle angle management

Programinės įrangos identifikatoriai (1)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
HPLA-14C568-TB 1.94.004MX53-14C570-BHC BOSCH MED17.8.32

ECU pastabos

MICRO Infineon Tricore TC1797 This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata