GWM - GREAT WALL MOTOR HOVER/HAVAL H6 2.0L 16V TURBO 145kW/194HP MED17.8.10

ECU BOSCH MED17.8.10 · 197 CV (145 kW) · 2000 cc · Benzina sovralimentato

ECU duomenų bazėGWM - GREAT WALL MOTOR › GWM - GREAT WALL MOTOR HOVER/HAVAL H6 2.0L 16V TURBO 145kW/194HP MED17.8.10

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) 1 programinės įrangos versijos

Transporto priemonės duomenys

MarkėGWM - GREAT WALL MOTOR
ModelisHOVER/HAVAL H6
Variklis2.0L 16V TURBO 145kW/194HP MED17.8.10
Serijinė galia197 CV / 145 kW
Darbinis tūris2000 cc
KurasBenzina sovralimentato
Transporto priemonės tipasAuto

ECU

GamintojasBOSCH
ModelisMED17.8.10
Atmintis / EPROMMICRO ST TRICORE - 12288 Kbit - 180000

Galimos derinimo operacijos / parinktys:

  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Knock correction advance max
  • Boost pressure
  • Boost pressure 2
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor to correct fuel delivery system
  • Engine idle vs. ECT sensor
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM limit for ECT sensor
  • RPM limit for EOT sensor
  • Knock detection factor
  • Lookup table minimum defined efficiency
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Max torque profile (overboost active)
  • Optimal engine moment
  • Driver torque request
  • Driver torque request City mode - AT
  • Driver torque request Normal mode - AT
  • Driver torque request Sport mode - AT
  • Driver torque request for reverse gear
  • Torque limiter for the 1st gear selected
  • Torque limiter for the 2nd gear selected
  • Torque limiter for the 3rd gear selected
  • Torque limiter for the 4th gear selected
  • Torque limiter for the 5th gear selected
  • Torque limiter for the 6th gear selected
  • Torque limiter for selected gear
  • Torque limiter for selected gear - AT
  • Torque limiter for for reverse gear
  • Throttle angle management
  • Turbocharger volumetric efficiency
  • Wastegate duty-cycle

Programinės įrangos identifikatoriai (1)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
F01R0ADG9GDJAO06AA22 1.00.017 BOSCH MED17.8.10

ECU pastabos

Microprocessor TC1728 To work on this ECU you can use NewTrasdata