Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.
✓ Derinimas failu (flash)
✓ Galimas papildomas modulis 2 programinės įrangos versijos
Transporto priemonės duomenys
| Markė | CITROEN |
| Modelis | C3 Mk2 |
| Variklis | 1.6L 16V HDI 82kW/110HP SID807 |
| Serijinė galia | 111 CV / 82 kW |
| Darbinis tūris | 1600 cc |
| Kuras | Diesel sovralimentato |
| Transporto priemonės tipas | Auto |
ECU
| Gamintojas | CONTINENTAL-SIEMENS-VDO |
| Modelis | SID807 |
| Atmintis / EPROM | M58BW016DB PQFP80 - Flash 3_V 512 x 32 |
Galimos derinimo operacijos / parinktys:
- Boost pressure limiter for diagnostics
- Boost pressure limiter
- BAP setpoint limitation depending on before particulate filter pressure in aftertreatment modes
- Boost pressure
- Boost pressure 2
- Boost pressure 3
- Boost pressure 4
- Load / throttle position reference
- Exhaust gas temperature value before turbine in regular injection mode
- Injection opening time related to inj. pressure
- J
- Torque limiter 2
- Torque limiter
- Intake manifold pressure
- Throttle air mass flow calculation
- Max torque profile
- Specific injection pressure limiter
- Specific injection pressure
- Driver torque request for high speed
- Driver torque request for medium speed
- Driver torque request for low speed
- Driver torque request at the start
- Driver torque request for reverse gear
- Torque limiter for EFT sensor
- Torque limit table for ECT sensor
- Torque model - fuel quantity to torque conversion
- Variable geometry duty cycle limit
Programinės įrangos identifikatoriai (2)
| Aparatinės įrangos Nr. | Programinės įrangos Nr. (lustas) | Versija | Atnaujinimo programinė įranga | ECU |
|---|
| 9663241480 | 9666571380 |
1.83.009 | 9678940580 |
CONTINENTAL-SIEMENS-VDO SID807 |
| 9663241480 | 9666571380 |
1.83.010 | 9667343480 |
CONTINENTAL-SIEMENS-VDO SID807 |
Techninės pastabos apie automobilį
OBD located to the left of the driver's side, under the steering column and behind the bulkhead or the lid in the fuse box area.
ECU pastabos
This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
Gaukite failą šiai transporto priemonei
Tools to read and write this ECU
