BMW MOTORRAD S 1000 R 17->20 121kW
ECU BOSCH ME17.2.4 BMS-MP · 165 CV (121 kW) · 1000 cc · Benzina aspirato
ECU duomenų bazė ›
BMW MOTORRAD › BMW MOTORRAD S 1000 R 17->20 121kW
Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.
✓ Derinimas failu (flash)
36 programinės įrangos versijos
Gaukite failą šiai transporto priemonei
Transporto priemonės duomenys
| Markė | BMW MOTORRAD |
| Modelis | S 1000 R |
| Variklis | 17->20 121kW |
| Serijinė galia | 165 CV / 121 kW |
| Darbinis tūris | 1000 cc |
| Kuras | Benzina aspirato |
| Transporto priemonės tipas | Moto |
ECU
| Gamintojas | BOSCH |
| Modelis | ME17.2.4 BMS-MP |
| Atmintis / EPROM | MICRO ST TRICORE - 32768 - 400000 |
Galimos derinimo operacijos / parinktys:
- Engine ignition timing versus temperature
- Advance at idle speed
- Lambda/AFR full load/WOT
- Advance at idle speed - warm up
- Optimal spark timing/MBT
- Advance at part load
- Advance at part load - warm up
- Automatic stability control 1
- Automatic stability control 2
- Automatic stability control 3
- Automatic stability control 4
- Automatic stability control 5
- Advance full load
- Advance full load - warm up
- Dynamic traction control
- Dynamic traction control 2
- Dynamic traction control 3
- Dynamic traction control 4
- Dynamic traction control 5
- Exhaust valve management
- Exhaust valve management - limiter
- Factor to correct fuel delivery system
- Engine torque reducing factor depending on engine speed
- Engine idle vs. ECT sensor
- Engine idle vs. ECT sensor 3
- Injection correction cilinder 1
- Injection correction cilinder 2
- Injection correction cilinder 3
- Injection correction cilinder 4
- Rpm threshold fuel cut
- Idle throttle angle correction for ECT sensor
- Advance limiter for component protection 1
- Advance limiter lower motor temperature threshold
- Advance limiter upper motor temperature threshold
- Torque limiter
- Lambda efficiency
- Exhaust valve opening limit
- RPM Limiter
- RPM Limiter 2
- RPM Limiter for gear downshift
- RPM limiter in limp mode
- RPM limiter - N
- Lambda driver wish
- Lambda driver wish 2
- Maximum indicated torque
- Optimal engine moment
- Specific injection pressure
- Air mass flow
- Exhaust gas temperature sensor
- Throttle angle limitation
- Throttle angle management
- Throttle angle management 2
- Cooling fan activation
- Front tire circumference
- Rear tire circumference
Programinės įrangos identifikatoriai (36)
| Aparatinės įrangos Nr. | Programinės įrangos Nr. (lustas) | Versija | Atnaujinimo programinė įranga | ECU |
|---|---|---|---|---|
| 00003747030001 | 0000304F09000A | 1.95.012 | 000041D009000B | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F0A0001 | 1.95.011 | 000041D70A0001 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F100000 | 1.95.020 | 000041D0100000 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F110000 | 1.95.011 | 000041D0110000 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F0C0000 | 1.95.004 | 000041D00C0000 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F120000 | 1.95.007 | 000041D8120001 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F0C0000 | 1.95.012 | 000041D00C0002 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F0D0000 | 1.95.004 | 000041D20D0000 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F0A0001 | 1.95.009 | 000041D80A0001 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F100000 | 1.95.004 | 0000588B100000 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F120000 | 1.95.016 | 000041D0120001 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F120000 | 1.95.005 | 0000588C120001 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F0C0000 | 1.95.004 | 000041D20C0000 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F0C0000 | 1.95.005 | 000041D20C0002 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F120000 | 1.95.012 | 000041D2120001 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F110000 | 1.95.010 | 000041D7110000 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F0D0000 | 1.95.017 | 000041D00D0000 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F110000 | 1.95.011 | 000041D2110000 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F120000 | 1.95.004 | 000041D7120000 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F0C0000 | 1.95.007 | 000041D20C0003 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F0D0000 | 1.95.002 | 0000588B0D0000 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F110000 | 1.95.008 | 000041D4110000 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F100000 | 1.95.007 | 000041D7100000 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F100000 | 1.95.010 | 000041CD100000 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F0A0001 | 1.95.017 | 000041D00A0001 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F0C0000 | 1.95.007 | 000041D70C0002 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F120000 | 1.95.005 | 00003C01120001 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F0C0000 | 1.95.013 | 000041D00C0003 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F120000 | 1.95.007 | 000041D2120000 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F120000 | 1.95.005 | 000041D7120001 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F120000 | 1.95.002 | 000041D3120001 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F0A0001 | 1.95.009 | 000041D20A0001 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F120000 | 1.95.011 | 000041D4120001 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F120000 | 1.95.013 | 000041D0120000 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F100000 | 1.95.007 | 000041D2100000 | BOSCH ME17.2.4 BMS-MP |
| 00003747050000 | 0000304F100000 | 1.95.004 | 000041D8100000 | BOSCH ME17.2.4 BMS-MP |
ECU pastabos
MICRO Infineon Tricore TC1793 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata ATTENTION - 78kW reduced power version file.
MICRO Infineon Tricore TC1793 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
