Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.
✓ Derinimas failu (flash)
✓ Galimas papildomas modulis 1 programinės įrangos versijos
Transporto priemonės duomenys
| Markė | AUDI |
| Modelis | TT (8N) |
| Variklis | 1.8L 20V TURBO 140KW/188HP ME7.5 |
| Serijinė galia | 190 CV / 14 kW |
| Darbinis tūris | 1800 cc |
| Kuras | Benzina sovralimentato |
| Transporto priemonės tipas | Auto |
ECU
| Gamintojas | BOSCH |
| Modelis | ME7.5 |
| Atmintis / EPROM | 29F800 PSOP44 8Mbit - Flash 512K x 16 |
Galimos derinimo operacijos / parinktys:
- Base timing
- Advance at idle speed
- Optimal spark timing/MBT
- Boost pressure limiter 4
- Boost pressure limiter 5
- Boost pressure limit control
- Height correction for boost pressure
- Desired engine load calculation
- Maximum pressure ratio limit for diagnosis
- Exhaust gas temperature
- Lambda enrichment for components protection
- RPM Limiter
- Boost pressure linearization
- Lambda driver wish
- Knock detection factor
- Speed limiter
- Maximum boost pressure load
- Manifold absolute pressure time delay
- Characteristic manifold absolute pressure time constant of the LRS
- Optimal engine moment
- Offset tolerance depending on permissible torque
- Relative permissible torque from the pedal position in torque limitation
- Pressure ratio depending on IAT
- Maximum pressure ratio limit depending on temperature
- Driver torque request
- Throttle angle management
- Variable intake pulsation correction
Programinės įrangos identifikatoriai (1)
| Aparatinės įrangos Nr. | Programinės įrangos Nr. (lustas) | Versija | Atnaujinimo programinė įranga | ECU |
|---|
| 0261201199 | 1037377682 |
1.42.018 | 8N0906018CS 0020 |
BOSCH ME7.5 |
Techninės pastabos apie automobilį
OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.
ECU pastabos
Original EPROM PSOP 44 pins 29F800BB. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. On this epron can be set a KEY. ATTENTION !! ME7 ECU ! You can use the emulator ONLY to see the TRACE. MODIFY with the emulator ONLY with the engine OFF; DON'T modify with the engine ON. IX/LCP = INJECTION AT FULL LOAD, DECREASE VALUE TO INCREASE INJECTION! This Setting File can be used for serial system NewGenius. Attention! If you use the serial system: before start the program, disconnect the feeding on the fans radiator.
Gaukite failą šiai transporto priemonei
Tools to read and write this ECU
