AUDI R8 (42) 5.2L V10 40V FSI 455kW/610HP MED17.1.1

ECU BOSCH MED17.1.1 · 619 CV (455 kW) · 5200 cc · Benzina sovralimentato

ECU duomenų bazėAUDI › AUDI R8 (42) 5.2L V10 40V FSI 455kW/610HP MED17.1.1

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) 1 programinės įrangos versijos

Transporto priemonės duomenys

MarkėAUDI
ModelisR8 (42)
Variklis5.2L V10 40V FSI 455kW/610HP MED17.1.1
Serijinė galia619 CV / 455 kW
Darbinis tūris5200 cc
KurasBenzina sovralimentato
Transporto priemonės tipasAuto

ECU

GamintojasBOSCH
ModelisMED17.1.1
Atmintis / EPROMMICRO ST TRICORE - 32768 Kbit - 400000

Galimos derinimo operacijos / parinktys:

  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor to correct fuel delivery system
  • High pressure fuel pump setpoint
  • High pressure fuel pump setpoint 2
  • High fuel pressure pump limit for ECT sensor
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM Limiter 2
  • Knock detection factor
  • Speed limiter
  • Maximum indicated torque
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • Relative permissible torque from the pedal position in torque limitation
  • Driver torque request
  • Driver torque request Sport mode
  • Torque limiter for selected gear
  • Throttle angle management

Programinės įrangos identifikatoriai (1)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
1.94.0024S0907552AL 0001 BOSCH MED17.1.1

ECU pastabos

MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata