AUDI Q3 (F3) 45 1.4L TFSI e-tron 110kW/147HP MED17.1.27

ECU BOSCH MED17.1.27 · 150 CV (11 kW) · 1400 cc · Hybrid

ECU duomenų bazėAUDI › AUDI Q3 (F3) 45 1.4L TFSI e-tron 110kW/147HP MED17.1.27

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) 3 programinės įrangos versijos

Transporto priemonės duomenys

MarkėAUDI
ModelisQ3 (F3)
Variklis45 1.4L TFSI e-tron 110kW/147HP MED17.1.27
Serijinė galia150 CV / 11 kW
Darbinis tūris1400 cc
KurasHybrid
Transporto priemonės tipasAuto

ECU

GamintojasBOSCH
ModelisMED17.1.27
Atmintis / EPROMMICRO ST TRICORE - 32768 - 400000

Galimos derinimo operacijos / parinktys:

  • Maximum air charge for overboost protection with turbocharger fault
  • Base timing
  • Optimal spark timing/MBT
  • Boost pressure limiter
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor for reducing maximum filling
  • Gearbox maximum torque allowed
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • Knock detection factor
  • Speed limiter
  • Maximum compression ratio
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • Power limit torque table
  • % relative air filling limit depending on IAT
  • Throttle angle management

Programinės įrangos identifikatoriai (3)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
1.94.00904E906024AN 3056 BOSCH MED17.1.27
1.94.00704E906024AN 1460 BOSCH MED17.1.27
1.94.00504E906024BS 1877 BOSCH MED17.1.27

ECU pastabos

MICRO Infineon Tricore TC1793 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata