AUDI A3 (8V) 1.5L 16V L4 TSI 110kW/148HP MG1CS011

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

Transporto priemonės duomenys

ECU

Galimos derinimo operacijos / parinktys:

• Base timing
• Advance at idle speed
• Minimum advance allowed
• Optimal spark timing/MBT
• Optimal spark timing/MBT 2
• Knock correction advance max
• Maximum engine boost pressure F (atmospheric pressure)
• Boost pressure limit control
• Desired engine load calculation
• Desired engine load calculation 2
• Lambda correction for engine temperature after starting
• Maximum torque limitation at clutch
• Compressor pressure ratio limit for pumping and speed
• Compression ratio for turbocharger protection
• Compression ratio limiting for compressor depending on IAT sensor
• Max accepted exhaust gas temperature at exhaust manifold
• Max accepted exhaust gas pressure at exhaust manifold
• Exhaust gas temperature
• Engine air charge correction for IAT sensor
• Engine air charge setpoint
• Minimum factor for air charge limitation
• Air charge offset to enable limitation
• Protection for engine overheating
• Minimum engine speed for charge monitoring
• Exhaust valves lift
• Max torque correction factor for APS sensor
• Engine torque reducing factor depending on temperature
• Max CAT temperature threshold for component protection
• Engine idle vs. ECT sensor
• Gearbox maximum torque allowed
• High pressure fuel pump setpoint
• High pressure fuel pump setpoint 2
• High fuel pressure pump limit for ECT sensor
• Intake valve lift
• Torque limiter 2
• Advance limiter for component protection 1
• Boost pressure deviation limits for basic charge air pressure
• Torque limiter
• Lambda enrichment for components protection
• Component protection activation delay
• Lambda minimum value for components protection
• Lambda value for components protection activation
• Lambda correction for exhaust manifold temperature
• RPM Limiter
• RPM Limiter 2
• RPM limiter 3
• RPM limiter - N
• RPM limiter in Park position
• RPM limit for ECT sensor
• RPM limit for EOT sensor
• Low pressure fuel pump limit
• Low pressure fuel pump limit for fuel mass flow
• Low pressure fuel pump for EFT sensor
• Lambda driver wish
• Driver torque request limiter
• Knock detection factor
• Speed limiter
• Cruise control speed limiter
• Maximum indicated torque
• Maximum indicated torque for monitoring
• Maximum compression ratio - monitoring
• Maximum engine air charge value
• Maximum engine temperature for torque limitation
• Manifold absolute pressure time delay
• Characteristic manifold absolute pressure time constant of the LRS
• Maximum intake manifold pressure
• Maximum relative engine air charge
• Maximum relative engine air charge - monitoring
• Max torque profile
• Optimal engine moment
• Protection for oil overheating
• Power limit torque table
• Turbo pressure variation control factor
• Turbo pressure variation control factor 2
• Revolution limiter
• Driver torque request
• Driver torque request 2
• Driver torque request 3
• Setpoint maximum turbocharger speed
• Target Lambda for knock protection
• Torque limiter in recovery mode
• Torque limiter in recovery mode 2
• Torque limiter in recovery mode 3
• Torque limiter in recovery mode 4
• Torque limiter in recovery mode 5

Programinės įrangos identifikatoriai (1)

ECU pastabos

Gaukite failą šiai transporto priemonei

Tools to read and write this ECU

Flex Programmatore per rimappatura centraline e cambi automatici ECU + auto gearbox € 1.000 Buy The Genius OBD + Bench € 2.500 Buy

Kiti AUDI

→ Visos ECU AUDI