Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.
✓ Derinimas failu (flash)
✓ Galimas papildomas modulis 3 programinės įrangos versijos
Transporto priemonės duomenys
| Markė | AUDI |
| Modelis | A1 (GB) |
| Variklis | 30 1.0L 12V TFSI 85kW/114HP MED17.1.27 |
| Serijinė galia | 116 CV / 85 kW |
| Darbinis tūris | 1000 cc |
| Kuras | Benzina sovralimentato |
| Transporto priemonės tipas | Auto |
ECU
| Gamintojas | BOSCH |
| Modelis | MED17.1.27 |
| Atmintis / EPROM | MICRO ST TRICORE - 32768 - 400000 |
Galimos derinimo operacijos / parinktys:
- Maximum air charge for overboost protection with turbocharger fault
- Base timing
- Optimal spark timing/MBT
- Boost pressure limiter
- Desired engine load calculation
- Lambda correction for engine temperature after starting
- Exhaust gas temperature
- Factor for reducing maximum filling
- Engine idle vs. ECT sensor
- Gearbox maximum torque allowed
- Lambda enrichment for components protection
- Lambda correction for exhaust manifold temperature
- RPM Limiter
- RPM Limiter 2
- RPM limiter 3
- Knock detection factor
- Speed limiter
- Maximum compression ratio
- Throttle air mass flow calculation
- Manifold absolute pressure time delay
- Characteristic manifold absolute pressure time constant of the LRS
- Max torque profile
- Optimal engine moment
- Power limit torque table
- Relative permissible torque from the pedal position in torque limitation
- % relative air filling limit depending on IAT
- Driver torque request
- Throttle angle management
Programinės įrangos identifikatoriai (3)
| Aparatinės įrangos Nr. | Programinės įrangos Nr. (lustas) | Versija | Atnaujinimo programinė įranga | ECU |
|---|
| — | — |
1.94.008 | 04C906025BF 7261 |
BOSCH MED17.1.27 |
| — | — |
1.94.010 | 04C906025H 5177 |
BOSCH MED17.1.27 |
| — | — |
1.94.008 | 04C906025M 6196 |
BOSCH MED17.1.27 |
Techninės pastabos apie automobilį
OBD located to the left of the driver's side, accessible without removing anything to the left of the pedalboard.
ECU pastabos
MICRO Infineon Tricore TC1793 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
Gaukite failą šiai transporto priemonei
Tools to read and write this ECU
