Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.
✓ Derinimas failu (flash)
4 programinės įrangos versijos
Transporto priemonės duomenys
| Markė | ALFA ROMEO |
| Modelis | 159 |
| Variklis | 3.2L V6 24V JTS Q4 191kW/256HP MED7.6.2 |
| Serijinė galia | 260 CV / 191 kW |
| Darbinis tūris | 3200 cc |
| Kuras | Benzina aspirato |
| Transporto priemonės tipas | Auto |
ECU
| Gamintojas | BOSCH |
| Modelis | MED7.6.2 |
| Atmintis / EPROM | 29F800 PSOP44 8Mbit - Flash 512K x 16 |
Galimos derinimo operacijos / parinktys:
- Base timing
- Optimal spark timing/MBT
- Desired engine load calculation
- Lambda correction for engine temperature after starting
- Exhaust gas temperature
- High pressure fuel pump setpoint
- High pressure fuel pump setpoint 2
- Torque limiter for diagnostic
- Lambda enrichment for components protection
- Lambda correction for exhaust manifold temperature
- RPM Limiter
- Lambda driver wish
- Knock detection factor
- Throttle air mass flow calculation
- Manifold absolute pressure time delay
- Characteristic manifold absolute pressure time constant of the LRS
- Optimal engine moment
- Offset tolerance depending on permissible torque
- Relative permissible torque from the pedal position in torque limitation
- Driver torque request
- Throttle angle management
- Variable intake pulsation correction
Programinės įrangos identifikatoriai (4)
| Aparatinės įrangos Nr. | Programinės įrangos Nr. (lustas) | Versija | Atnaujinimo programinė įranga | ECU |
|---|
| 0261S01043 | 1037380160 |
1.93.007 | — |
BOSCH MED7.6.2 |
| 0261S01043 | 1037386439 |
1.93.002 | — |
BOSCH MED7.6.2 |
| 0261S01056 | 1037384769 |
1.93.004 | — |
BOSCH MED7.6.2 |
| 0261S01073 | 1037395019 |
1.93.002 | — |
BOSCH MED7.6.2 |
Techninės pastabos apie automobilį
OBD located to the left of the driver's side, under the steering column and behind the bulkhead or the lid in the fuse box area.
ECU pastabos
Original EPROM PSOP 44 pins 29F800BB. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. On this epron can be set a KEY. ATTENTION !! ME7 ECU ! You can use the emulator ONLY to see the TRACE. MODIFY with the emulator ONLY with the engine OFF; DON'T modify with the engine ON. IX/LCP = INJECTION AT FULL LOAD, DECREASE VALUE TO INCREASE INJECTION! Attention! If you use the serial system: before start the program, disconnect the feeding on the fans radiator. This Setting File can be used for serial system : Genius or NewGenius. To work on this ECU you can use NewTrasdata
Gaukite failą šiai transporto priemonei
Tools to read and write this ECU
